Quote:
Originally Posted by Future240
SR20 bearings. I was watching a video of a guy rebuilding one (S13) and he said that the block has numbers on it that correspond to bearing sizes and you have to match the bearing sizes to each number listed on the block. Over the years I have seen many of you talk about building SR20's and have never seen this bearing thing mentioned.
video I am talking about starts at 3:40
https://www.youtube.com/watch?v=BdvnIPHNKM8
I guess my question is, is this correct? He literally says you cannot just buy a set of ACL race bearings and throw in their yet I see a lot of builds doing just that. |
Quote:
Originally Posted by Agamemnon
He's correct. I just checked my S14 SR manual and the same procedure is listed in the FSM.
|
Circling back to this.
FSM says to use oversized bearings if the crankshot measurements are off. Are the oversized bearings good enough or do they need to be matched like regular bearings?