Quote:
Originally Posted by Jefro240
That is where I'd start... If that LCA is as you say it can definitely cause issues and myself, I'd be swapping out that out. Then I'd go back over the kit and make sure its installed 100% correctly.
|
That's my first plan. I just find it hard to think that a little bit of bending axially would cause major changes laterally....if that makes any sense. Thanks for the reply though, I'm definitely getting new arms.
Quote:
Originally Posted by gaz_moose
take both LCA's off and put them side by side on a flat surface.
|
I'll end up doing this when I change my arms.