Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Go Back   Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum > General > Tech Talk

Tech Talk Technical Discussion About The Nissan 240SX and Nissan Z Cars


Reply
 
Thread Tools Display Modes
Old 05-31-2006, 05:45 AM   #1
WhittSr20det
 
WhittSr20det's Avatar
 
Join Date: May 2006
Location: Ashland,Ky
Posts: 33
Trader Rating: (0)
WhittSr20det is an unknown quantity at this point
Feedback Score: 0 reviews
Exclamation sr20det TRANNY SPRAYING GEAR OIL EVERYWHERE!!!

I have a 92 240sx coupe with a Black top... Anyways after driving my car for a while with a couple of friends i notice my tranny is slightly grinding in between gears just here and there so i look underneath my car and i spot some gear oil "i know it was gearoil cause i gave it a good taste taste with my finger" so i drive home. thought maybe it was jsut from racing and it blew a little out the breather on top of the tranny so the next night went to race a GT drove there fine no porblems well when i get into the car try to put in it first grinded like hell so i was like f this .. went got gear oil drained the rest out .. put the 3half qrts in or what not today wake up going to my girls house to pick her up ... notice its grinding again so pull off the road into a church look under the car and gear oil is pouring ..not out the rear where the drive shaft is but from the top right where the breather is ...... get it 2 a freinds house and look again to make sure it wasnt coming from anywhere else and only that side of the tranny is covered...
so is there any lines that run on the breather on the tranny .. if so where do they go... or anyoneelse had this problem...
cant figure anything out
WhittSr20det is offline   Reply With Quote
Sponsored Links
Old 05-31-2006, 06:33 AM   #2
NIK90s13
Zilvia Junkie
 
NIK90s13's Avatar
 
Join Date: Jan 2006
Location: texas
Age: 58
Posts: 471
Trader Rating: (0)
NIK90s13 is making a name for him/her selfNIK90s13 is making a name for him/her self
Feedback Score: 0 reviews
If I understand right, your rear seal where the drive shaft is blown, replace it and you should be good.
NIK90s13 is offline   Reply With Quote
Old 05-31-2006, 10:26 AM   #3
hernameissilvia
 
Join Date: Apr 2006
Location: Orlando, FL
Posts: 20
Trader Rating: (0)
hernameissilvia is an unknown quantity at this point
Feedback Score: 0 reviews
I may be wrong since his grammar is horrible. I think he said its NOT leaking from the rear seal, but from the breather at the top of the bell housing.
In which case, I had this problem too.

I filled my tranny as specified, but after driving the whole side of the tranny would be covered in oil. It leaks out because its too full. I never refilled mine and I have no problems. It may just be your syncros going or a bad tranny.
hernameissilvia is offline   Reply With Quote
Old 05-31-2006, 10:31 AM   #4
aznpoopy
Post Whore!
 
aznpoopy's Avatar
 
Join Date: Mar 2003
Location: New Jersey
Age: 44
Posts: 5,013
Trader Rating: (1)
aznpoopy has a reputation beyond reputeaznpoopy has a reputation beyond reputeaznpoopy has a reputation beyond reputeaznpoopy has a reputation beyond reputeaznpoopy has a reputation beyond reputeaznpoopy has a reputation beyond reputeaznpoopy has a reputation beyond reputeaznpoopy has a reputation beyond reputeaznpoopy has a reputation beyond reputeaznpoopy has a reputation beyond reputeaznpoopy has a reputation beyond repute
Feedback Score: 1 reviews
Send a message via AIM to aznpoopy
get some real MT fluid instead of just gear oil.
when you fill it, do it the right way. when the tranny is cold, stick your finger in the fill hole. if it's right up to the bottom of the hole, you're good.

do you have a rubber hose running on the breather?

oh, and you don't have to taste the oil... gear/tranny oil has a very distinctive smell. just sniff it next time! lol.
aznpoopy is offline   Reply With Quote
Old 05-31-2006, 02:32 PM   #5
Vatche
Post Whore!
 
Vatche's Avatar
 
Join Date: Feb 2003
Location: Los Feliz
Age: 42
Posts: 5,917
Trader Rating: (289)
Vatche is close to perfectionVatche is close to perfectionVatche is close to perfectionVatche is close to perfectionVatche is close to perfectionVatche is close to perfectionVatche is close to perfectionVatche is close to perfectionVatche is close to perfectionVatche is close to perfectionVatche is close to perfection
Feedback Score: 289 reviews
ive had this problem ever since i got myself a obx short shifter from a friend. what happened is on the stock shifter there is a rubber boot that seals the shifter. the obx is a different design then stock because theyre a pos company and make stupid shit so i had no rubber seal there(which if anyone knows where i can buy one or whatever lemme know, i just made something temporarily) but point being my tranny would leak out from there, and even though i filled it to level....it would leak fromthe top and that caused my shit to grind also and my second gear syncro started going bad....so make sure you have a rubber boot sealing the top of your shifter.
__________________
Quote:
Originally Posted by Jung918
I dub thy the socal zilvia slut.
The Ultimate For Sale Thread <> Review Thread

Last edited by Vatche; 06-03-2006 at 04:08 PM..
Vatche is offline   Reply With Quote
Old 06-02-2006, 06:04 PM   #6
WhittSr20det
 
WhittSr20det's Avatar
 
Join Date: May 2006
Location: Ashland,Ky
Posts: 33
Trader Rating: (0)
WhittSr20det is an unknown quantity at this point
Feedback Score: 0 reviews
yeah the hose from the top of my tranny had came off so i put one on problem solved..
WhittSr20det is offline   Reply With Quote
Reply

Bookmarks


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 12:34 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vB.Sponsors
Copyright ? 1998 - 2022, Zilvia.net