z32 maf wiring, concerns - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

devonkyle77 · 08-24-2008, 04:14 PM

ok so i am installing a z32 maf and i am concerned with the splicing of the pigtail to the engine harness wires. as i understand it, it is very important that the maf wires be "shielded" the plug/pigtail that came with my greddy intake doesnt appear to have shielded wires. the wires from my engine harness were extended long enough by phase 2 when they did my harness that they will reach to the plug no problem.

so should i use as little of the wire on the plug as possible? what are your suggestions?
thanks in advance!

08-24-2008, 04:14 PM	#1
devonkyle77 Post Whore! Join Date: Sep 2003 Location: md Age: 41 Posts: 3,091 Trader Rating: (3) Rides Gallery: devonkyle77 Feedback Score: 3 reviews	z32 maf wiring, concerns ok so i am installing a z32 maf and i am concerned with the splicing of the pigtail to the engine harness wires. as i understand it, it is very important that the maf wires be "shielded" the plug/pigtail that came with my greddy intake doesnt appear to have shielded wires. the wires from my engine harness were extended long enough by phase 2 when they did my harness that they will reach to the plug no problem. so should i use as little of the wire on the plug as possible? what are your suggestions? thanks in advance! __________________ WTB-NARDI wheel & NRG 2.8 QR

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode