grafting an intake - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

N1ceDrgn · 02-11-2003, 07:56 AM

Right now I have a CA setup but this question applies to anyone with an intercooler. I am curious that if I grafted another piece into my intake piping, (intake side of the engine), would that decrease or cause any problems? I am looking at grafting a section into my intercooler piping and relocating my MAF. I've relocated my battery to the trunk and I would run the MAF and air cleaner to the battery tray, (to give you an idea). After sealing the intake on the turbine side of the engine, or running open face, relocating that assembly to the other side, would there be any issues with this? The amount of pressure would be the same I presume however, does any one have any ideas or maybe seen this some where?

02-11-2003, 07:56 AM	#1
N1ceDrgn Zilvia Member Join Date: Nov 2002 Location: SoCal Posts: 259 Trader Rating: (0) Feedback Score: 0 reviews	grafting an intake Right now I have a CA setup but this question applies to anyone with an intercooler. I am curious that if I grafted another piece into my intake piping, (intake side of the engine), would that decrease or cause any problems? I am looking at grafting a section into my intercooler piping and relocating my MAF. I've relocated my battery to the trunk and I would run the MAF and air cleaner to the battery tray, (to give you an idea). After sealing the intake on the turbine side of the engine, or running open face, relocating that assembly to the other side, would there be any issues with this? The amount of pressure would be the same I presume however, does any one have any ideas or maybe seen this some where? __________________ ..working on something that is slowly getting built up and restored..

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode