Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Go Back   Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum > General > Tech Talk

Tech Talk Technical Discussion About The Nissan 240SX and Nissan Z Cars


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 03-12-2009, 09:50 PM   #1
corey240
Zilvia Junkie
 
corey240's Avatar
 
Join Date: Dec 2005
Location: Cumberland, Maryland
Age: 36
Posts: 508
Trader Rating: (2)
corey240 is not welcome here anymorecorey240 is not welcome here anymorecorey240 is not welcome here anymorecorey240 is not welcome here anymorecorey240 is not welcome here anymorecorey240 is not welcome here anymorecorey240 is not welcome here anymorecorey240 is not welcome here anymore
Feedback Score: 2 reviews
Send a message via AIM to corey240 Send a message via MSN to corey240
Clutch slipping/not engaging right need advice

Ok so I bought a good condition used hyper single. It is pretty nice and beter condition the my HKS was when I got it. I installed everything rgiht. I finally got to drive the car after finishing the assembly today and was struck with confusion.

The clutch didnt engage until it was basically 100% out. On top of that, it slipped so bad I stopped driving it. I called and talked to someone legit and he told me to adjust the clutch pedal. I have no goten it to the point where if I make the bolt any looser it will fall out. It helped alot but the FSM says the pedal to floor distance should be somwhere between 7.5?-7.9? inches. Mine is basically 7.

When I installed the slave it was hell. I had to do my damndest to get it on, releasing the fluid in it and still had trouble. I remember reading about people cutting the pins on the slave for some reason and I think this is why. My slave is brand new and works fine but I think the pin is a little too long and the clutch is just fine but I cant seem to figure it out.

We bled the system good today and it helped but not good to drive on the main road. I am going to bleed again tomorow and if that doesnt work I am cutting the pin shorter slightly to try and get it working. I have spare slaves with pins so its no concern to hack one.

Does anyone have advice on this of have had this problem befor?
__________________
Email: [email protected]
corey240 is offline   Reply With Quote
Sponsored Links
 

Bookmarks


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 03:22 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vB.Sponsors
Copyright ? 1998 - 2022, Zilvia.net