Quick question about pilot bushing - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Rownan · 03-11-2004, 12:19 PM

I noticed that my new pilot bushing slid loosely over the input shaft of the trans before I installed it... I tapped it into the back of the crank, and I now have two concerns........

My clutch alignment tool barily fits into the bushing. I can only get the tip into the bushing. This leads my to believe that the bushing was compressed when I hammered it into the hole.......? Is the hole tapered and maybe I hammered it too far back in? How far in is the bushing supposed to be?

03-11-2004, 12:19 PM	#1
Rownan Leaky Injector Join Date: Apr 2002 Location: Waterford, MI Age: 43 Posts: 133 Trader Rating: (0) Feedback Score: 0 reviews	Quick question about pilot bushing I noticed that my new pilot bushing slid loosely over the input shaft of the trans before I installed it... I tapped it into the back of the crank, and I now have two concerns........ My clutch alignment tool barily fits into the bushing. I can only get the tip into the bushing. This leads my to believe that the bushing was compressed when I hammered it into the hole.......? Is the hole tapered and maybe I hammered it too far back in? How far in is the bushing supposed to be?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode