NV lots ofparts,s13 HUD,spacers,rad,skirts,Painless wiring,axle,z32 maf,bride rails

[ExiledLakai]

all prices are OBO, lowballers won't be responded to. PM me for quickest response. prices do not include PPal or shipping fees

25mm billet spacers. 5x114.5 the studs are however 1.5 which isn't the thread pitch of nissan studs so they will come with the Ti lugs. $150


side skirts for S13 hatch. Battled a little but are still good to go. $50


Z32 maf and pig tail $70



power steering cooler and lines $40


Painless wiring harness. Plug and play with SR20 powered car. Plugs directly into the s13 chassis harness. You still have to run wires to any accessories you have. Also comes with a fuel pump relay with wired stock plug for drop in fuel pumps. $550... yes $550 99% of the labor is done for you, think about it.







Godspeed Al rad $100


reman s13 axle only one event on it. practically still new $75


bride seat rail. s13 drivers side $200


Hud cluster and display(working) comes with sub harness, also comes with plugs wired for just illumination, fuel gauge, tach, and speedo. $200

pink gas gauge, black ground, yellows are power(if putting in a car race)

speedo plug are a race car(sr/ka tranny)

plug n plug to the sr ecu for tach.



Thanks for looking!

[ExiledLakai]

all pm's replied to.