WTB: AEM UEGI Wideband GAUGE ONLY (troubleshooting question also)

[silvia910]

Replaced my sensor and repaired sensor harness, but apparently the gauge is what needs to be replaced. Can't seem to find anywhere to buy the gauge only so if anyone has one in known working condition I'll take it.

Or if anyone has any idea why my gauge reads all the way lean always, some insight would be nice. Checked continuity of all wire on sensor harness, checked out. Replaced sensor with Bosch 17018. Even did brake cleaner rag test, gauge still always reads lean and doesn't move. Even with the sensor harness unplugged from back of gauge, when ignition is turned to on, it would run through the starting scrolling sequence and then just immediately reads full lean (---). Apparently it should read 14.7 initially, with sensor harness unplugged. Get is set to p0. Any ideas?