quick bov and intercooler piping question

[BigBoizSilvia]

1)Got a 95 s14 with ka24de-t.. installing a front mount intercooler with a length of 29" from end to end and 7" tall and 2.5" wide with inlet and outlets of 2.5"..
2)Got a T25 turbo..
3)my setup so far for the piping is going to be air intake is 2.75" piping with maf and a tube for recirculation from the bov..
4)K from the air compressor side will come out with a 1g dsm bov on 2" piping.. it will recirculate into the intake tube after the maf and back into the turbo..
5)from the 2" piping it will go down to about a 1 ft of 2.5 in pipng
6)Then into the intercooler and then 2.5" piping out
7)then to a short 2.75" cold pipe back into the intake manifold.

My question is .. without the bov crushed, will this be a fine set up to run 7 psi daily and 10-12 psi max? Or where is the best place to recirculate and place the BOV... here is a quick pic i did through photoshop..