Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Go Back   Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum > General > Tech Talk

Tech Talk Technical Discussion About The Nissan 240SX and Nissan Z Cars


Reply
 
Thread Tools Display Modes
Old 06-01-2002, 11:41 AM   #1
maddindian
Leaky Injector
 
Join Date: Nov 2001
Posts: 69
Trader Rating: (0)
maddindian is an unknown quantity at this point
Feedback Score: 0 reviews
Send a message via ICQ to maddindian
How I run cables from the trunk to the dash? I know there's an opening where the white harness is on the top of hte passenger side of the rear deck.

However when I try putting a cable through there it gets stuck. How does the cable route from that opening? I tried prying away the side panels by the door and saw that it goes down to below the rear seats. However I am not positive if it actually goes below the seats or runs to the side of them. I think it also meets up at the 'hump' in the center and runs up the tranny tunnel to the console...am I right?

If I am, how do I get my cables to follow that route???

Thanks!
__________________
-> '99 Maxima GLE <fully loaded>
-> '95 240SX LE 5-spd <fully loaded>
maddindian is offline   Reply With Quote
Sponsored Links
Old 06-02-2002, 12:34 AM   #2
SR20DET S14
Leaky Injector
 
Join Date: Mar 2002
Posts: 87
Trader Rating: (0)
SR20DET S14 is an unknown quantity at this point
Feedback Score: 0 reviews
i think the easiest way would b by running it with other wires through the drivers side. if u take off the rear seat and the cover on the drivers side, u'll see everything.
hope that helps
SR20DET S14 is offline   Reply With Quote
Old 06-02-2002, 05:02 PM   #3
gfisch
Zilvia Junkie
 
gfisch's Avatar
 
Join Date: May 2001
Location: Warren,NJ / Baltimore,MD
Age: 44
Posts: 576
Trader Rating: (0)
gfisch is an unknown quantity at this point
Feedback Score: 0 reviews
Send a message via AIM to gfisch
Well, I ran them down the side of the back seat, behind the panel to the side of the rear passenger, and under the carpet(pull up the trim on the bottom of the door fram and pull back the carpet a bit), then up into the kick panel, and under the dash to the stereo.
If your running wires to an amp, I'd reccomend running the power wires down one side and the signal wires down the other to reduce and interference.

Thats  how I did it and you couldnt see any part of any of the wires except as the popped out of the side of the carpet lining the deck in the trunk.
__________________
Greg Fischer
[email protected]
'97 240SX SE
'98 Ford Explorer XLT
gfisch is offline   Reply With Quote
Reply

Bookmarks



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 04:23 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vB.Sponsors
Copyright ? 1998 - 2022, Zilvia.net