dented area on trans - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

misfitsfreak81 · 04-19-2006, 10:03 PM

alright guys i searched as much as possible and could not find any threads pertaning to this question. so here it goes. i just picked up a blacktop s13 motor and am in the process of lookin it over and tearin it apart to check everything. i noticed that the area near the output shaft of the trans is dented. kinda looks like it was hit with a hammer or somethin. its on the machined surface at the end of the tranny. i have posted a pick so you can see where im talkin about.

please let me know how bad this is. like if i should send the motor back or try to get a different tranny from the company that sold it to me. im not super happy with them anyway. the harness is cut in like 7 spots and the turbo has quite a bit of shaft play.

thanks for any help provided.

misfitsfreak81 · 04-19-2006, 10:29 PM

well i tried to post a pic but it was too big. it is the machined area where the trans would conect to the drive shaft if that helps any. please gimme a hand with this one. thanks guys

04-19-2006, 10:03 PM	#1
misfitsfreak81 Zilvia Junkie Join Date: Dec 2005 Location: northern suck Posts: 354 Trader Rating: (1) Feedback Score: 1 reviews	dented area on trans alright guys i searched as much as possible and could not find any threads pertaning to this question. so here it goes. i just picked up a blacktop s13 motor and am in the process of lookin it over and tearin it apart to check everything. i noticed that the area near the output shaft of the trans is dented. kinda looks like it was hit with a hammer or somethin. its on the machined surface at the end of the tranny. i have posted a pick so you can see where im talkin about. please let me know how bad this is. like if i should send the motor back or try to get a different tranny from the company that sold it to me. im not super happy with them anyway. the harness is cut in like 7 spots and the turbo has quite a bit of shaft play. thanks for any help provided.

04-19-2006, 10:29 PM	#2
misfitsfreak81 Zilvia Junkie Join Date: Dec 2005 Location: northern suck Posts: 354 Trader Rating: (1) Feedback Score: 1 reviews	well i tried to post a pic but it was too big. it is the machined area where the trans would conect to the drive shaft if that helps any. please gimme a hand with this one. thanks guys