Is it possible to change the angle of s14 projectors? - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Xcede · 06-18-2008, 09:31 PM

Hey guys i was just wondering if it was possible to change the angle of the kouki projectors? when i drive it seems like the left projector is angled higher then the right because i can only see the out line of the top of the right light on the floor (if you know what im trying to say) if anyone knows if you can thanks! =]

projectRDM · 06-18-2008, 09:58 PM

Aim them. With the aiming screws. That are found on the headlights.

Was that really that hard?

*ziptiedae86* · 06-18-2008, 10:12 PM

yeah there are 2 screws behind each headlight one for lateral (left and right) and one vertical.

look at the headlight you think is aimed properly and note where the air bubble is on that side, then adjust the vertical screw (8mm wrench) until the air bubble is in the same position as the other side. you can adjust the left right by using the other screw NEXT to the one with the LR directions on it. both the low and high beams are adjusted together.

really not too difficult at all lol

gl

06-18-2008, 09:31 PM	#1
Xcede Leaky Injector Join Date: Dec 2007 Location: Chino Hills Posts: 61 Trader Rating: (0) Feedback Score: 0 reviews	Is it possible to change the angle of s14 projectors? Hey guys i was just wondering if it was possible to change the angle of the kouki projectors? when i drive it seems like the left projector is angled higher then the right because i can only see the out line of the top of the right light on the floor (if you know what im trying to say) if anyone knows if you can thanks! =]

06-18-2008, 09:58 PM	#2
projectRDM Post Whore! Join Date: Dec 2002 Location: Atlanta Age: 51 Posts: 13,812 Trader Rating: (12) Feedback Score: 12 reviews	Aim them. With the aiming screws. That are found on the headlights. Was that really that hard? __________________ FORMERLY R240NA Learn what's really going on and protect your assets now before they're gone forever: www.paypalsucks.com

06-18-2008, 10:12 PM	#3
ziptiedae86 Premium Member Join Date: May 2006 Location: Austin Age: 41 Posts: 179 Trader Rating: (2) Feedback Score: 2 reviews	yeah there are 2 screws behind each headlight one for lateral (left and right) and one vertical. look at the headlight you think is aimed properly and note where the air bubble is on that side, then adjust the vertical screw (8mm wrench) until the air bubble is in the same position as the other side. you can adjust the left right by using the other screw NEXT to the one with the LR directions on it. both the low and high beams are adjusted together. really not too difficult at all lol gl