CA FS: Kouki sr20det semi-built

[my05panda]

Got a complete swap for sale. as title states its a kouki sr20det so it has forged internals stock, bottom end is completely stock head is built, has bc cams springs retainers, greddy rocker arm stoppers. garret gt2871r with hks actuator. comes with s14 tranny and ORC single plate clutch. REAL greddy oil pan not a knock off, braided oil lines for turbo. also has apexi metal head gasket.

Also comes with Power FC l-jetro with hand held controller. motor runs perfect but needs tune. was purchased and then bought the turbo setup and stand alone. all mods have just a couple dyno pulls on them and thats it. motor was pulled due to goin a different route. pulls hard and doesnt leak a drop

imsure im missing a couple things but got most of em covered.

asking 4500 obo for complete swap. all you need is harness.

ive got way more into this motor. but need to get rid of it to fund the new motor.

[sam2145871]

If you decide to part it I would be interested in the turbo w/ actuator and the oil pan. Let me know. Thanks!

[my05panda]

Originally Posted by sam2145871

If you decide to part it I would be interested in the turbo w/ actuator and the oil pan. Let me know. Thanks!

not looking to part. but if i do i will def. let you kno

[my05panda]

1st bump.... some one shoot me an offer

[my05panda]

BUmp 2.... dang i guess economy is killin people

[sirfallsalot243]

Who told you the kouki SR came stock with forged internals?

And why would someone spend all the money for a PFC and a 2871r only to put it on the dyno, do a few pulls, never even tune it, and then pull it back out? Not calling you a liar, it just seems weird to me. At the very least, i would think you'd have tuned it, since you have everything needed to do so, that way you could post a dyno sheet with it to verify that its in good running condition.

[my05panda]

Originally Posted by sirfallsalot243

Who told you the kouki SR came stock with forged internals?

And why would someone spend all the money for a PFC and a 2871r only to put it on the dyno, do a few pulls, never even tune it, and then pull it back out? Not calling you a liar, it just seems weird to me. At the very least, i would think you'd have tuned it, since you have everything needed to do so, that way you could post a dyno sheet with it to verify that its in good running condition.

**SOLD YESTERDAY MODS PLEASE DELETE**

but ill explain anyway so people dont think i was trying to scam lol
not full forged internals but forged pistons. was told this by a master tech for nissan that builds motors on the side. But thats just what he told me i just took his word for it

its understandable where your coming from. motor was put together and taken to get tuned on hks vpro. but the vpro was bad and would not link up with the computer to tune it. so i decided to go a different route with a motor and picked up a power fc from a friend just to sell with the swap.

i have videos of the car when motor was in and it idles and revs fine. just not driveable due to not being tuned. a couple people came to look at it and seen it run all i have to do is run power to it since the harness only has the wires needed for it to run (2 power wires and some grounds). and i have a small fuel tank with pump i hook up to it and it starts right up.

*edit* only motor set was sold. the power fc is still for sale.