Clutch not fully engaging

[40sALLday]

So I bought new clutch, cm, and slave for my ka de And my problem is when I put everything back together the car wouldn't engage. It's as if it's stuck in nuetral but it rolls. Just not grabbing the gear all the way the car also doesn't turn off in gear when I let off the pedal. I was thinking maybe the throw out bearing isn't returning all the way? Or maybe my slave is bad? But I'm not too sure. Kinda new to 240s so all and any help will be cool.

[soreballz]

Make sure the shift fork has its full range of motion.

You probably just need to adjust the pedal. It took me a while to get my pedal right after my last clutch job.

[fliprayzin240sx]

Pedal adjustment...

[40sALLday]

Originally Posted by soreballz

Make sure the shift fork has its full range of motion.

You probably just need to adjust the pedal. It took me a while to get my pedal right after my last clutch job.

Yea been trying the adjustment on my pedal but it will either grab at the top but not fully engaged. Or nothing happens at all if I adjust it lower? Idk if that makes sense? But it does look like the fork doesn't go back enough. Slave looks like it still has a little to return completely but it pushes the fork enough to disengage

[Garage Life]

How's your flywheel? I had the same problem with my s13 and when I took everything apart and had the flywheel resurfaced, it solved the problem.

[40sALLday]

Originally Posted by Garage Life

How's your flywheel? I had the same problem with my s13 and when I took everything apart and had the flywheel resurfaced, it solved the problem.

had it resurfaced when i changed everything. havent touched it since..

[Garage Life]

Is the clutch torqed in properly? its possible that the clutch a pressure plate wasnt tightened down properly. Also make sure the hydrolic are working. Have a friend pump the clutch while your under the car watching the slave push the fork back and forth. If it is working, its most likely your clutch and pressure plate arent grabbing

[Southern Elegance]

Originally Posted by Garage Life

Is the clutch torqed in properly? its possible that the clutch a pressure plate wasnt tightened down properly. Also make sure the hydrolic are working. Have a friend pump the clutch while your under the car watching the slave push the fork back and forth. If it is working, its most likely your clutch and pressure plate arent grabbing

possibly this and my friend has run into the throwout bearing clip to popping off sometimes so the bearing just kinda slides around. i'd double check and make sure everything was installed correctly.

[40sALLday]

Originally Posted by Southern Elegance

possibly this and my friend has run into the throwout bearing clip to popping off sometimes so the bearing just kinda slides around. i'd double check and make sure everything was installed correctly.

Old clip to throw out was bent a lil but I tryed to make it stay in place better but I just had a different tranny rebuilt picked it up yesterday. Also bought new clips. Gonna check everything twice before slapping it on. Pressure plate, clutch ect.

[WIKID S4TEEN]

Originally Posted by 40sALLday

I just had a different tranny rebuilt picked it up yesterday.

Hey, I don't mean to thread jack....but where did you get your tranny rebuilt? I need that done, I'm in Palmdale too.
Thanks in advance and GL with your car!

[40sALLday]

Originally Posted by WIKID S4TEEN

Hey, I don't mean to thread jack....but where did you get your tranny rebuilt? I need that done, I'm in Palmdale too.
Thanks in advance and GL with your car!

my freind from wyotech. i just had to buy the parts and he did it for me..