|
|
|||||||
| Engine Tech Technical discussion related to all relevant engines such as KA, SR, RB, CA, 2JZ , L24/26/28, VG, VQ, and LSx series. |
 |
|
|
Thread Tools | Display Modes |
09-10-2012, 11:27 AM
|
#1 |
|
Zilvia Member
 Join Date: Jun 2011
Location: Fredericksburg,VA
Age: 34
Posts: 178
Trader Rating: (3)
 Feedback Score: 3 reviews
|
S14 Sr20 Intake manifold on sr20ve head?
I've now heard from 2 different sources that a s14 sr20 intake manifold fits on an sr20ve to make it front facing, and the only thing I would need to do is port it? Not really worried about doing it since I'm going with an excessive intake, but now it definitely has me curious.
|
|
|
| Sponsored Links |
|
09-10-2012, 01:33 PM
|
#2 |
|
Post Whore!
 |
No, it doesn't... Bolt pattern is wrong. You could cut the flange off and weld a VVL one on however. Below is a picture of a VE intake gasket overlaid on an S14 intake gasket.
__________________
*My SR20VET* Does your VTC gear rattle in your S14/15 SR? PM me. |
|
|
|
|
09-10-2012, 03:28 PM
|
#3 |
|
Zilvia FREAK!
 
|
It's basically as mentioned above a cut and weld reusing the VE lower intake plenum. This is the pic that I saw that did that. There is another thing to consider going this route is the coolant lines. VE are like S13 where to coolant / heater line from the head is separate from the intake manifold.
 |
|
|
|
|
09-10-2012, 03:32 PM
|
#4 |
|
Zilvia FREAK!
|
I'm doing a similar build but I'm going for something cheaper route on the Intake manifold. I plan on keeping lower VE Intake planum and match it with a universal intake plenum using the original gasket. This will keep the cost down to less than 150 once it all done.
Ross Machine Racing - Plenum Extrusions  |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
