SR swap running issue-you'll have to be pretty smart for this one.....

[Spdrules5]

Blacktop SR20DET with 5spd into 89 coupe (auto to man conversion done).
Car will barely start, then runs on two cylinders(the middle two only). I unplug the MAF and it makes no difference, BUT, the RPM's WILL raise over 2500 rpm no problem.

I have:
- replaced MAF with known good one--no change
- replaced ECU with known good one--no change
- replaced CAS with known good one--no change
- chkd' continuity between sensor plugs and blue ECU plug--all seem good
- replaced wire harness with known good one--NO change!
- pulled valve cover and put CAS 180* off--would not start

I have pulled each coil pack one at a time and checked:
-spark across gap--all fire
-constant 12v to top of coils--all good
-ground--all good
-signal--something measured as it fired
-all gapped at 0.032

All grounds are attached in approprite places

I am at a total loss. Please help.

Thanks in advance