HELP pulling a motor - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

wickedjester · 06-20-2008, 01:20 AM

so long story short we went to do a head gasket on my buddys ka24de and we got the head off and low a behold he has low comp pistons (i guess previous owner was going for a ka-t) so we decided to just swap it with a motor from the junk yard and build that motor for our project .

so we un bolt all but one tranny bolts and the one left is on the exhaust side and it goes though the tranny and motor and comes out the other side w/o a nut. wrenching on it does nothing cept spin it in place im outta ideas ne suggestions would be nice and greatly appriciated..

thank you

06-20-2008, 01:20 AM	#1
wickedjester Zilvia Junkie Join Date: Jan 2008 Location: escondido Age: 36 Posts: 511 Trader Rating: (4) Feedback Score: 4 reviews	HELP pulling a motor so long story short we went to do a head gasket on my buddys ka24de and we got the head off and low a behold he has low comp pistons (i guess previous owner was going for a ka-t) so we decided to just swap it with a motor from the junk yard and build that motor for our project . so we un bolt all but one tranny bolts and the one left is on the exhaust side and it goes though the tranny and motor and comes out the other side w/o a nut. wrenching on it does nothing cept spin it in place im outta ideas ne suggestions would be nice and greatly appriciated.. thank you __________________ ur car door says protect and serve but on the street its harass and disturb

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode