Re use of intake manifold gasket. - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

oscarsx · 07-15-2013, 12:06 PM

I did an emission removal on my s14, long story short. I firmly believe I have a vacuum leak somewhere so I'm planning on removing my manifold.

I just installed a new felpro intake gasket with less than 5 miles on the car, if I was to remove my manifold could I re use the gaskets again? I could order new ones but that would then a few days for me to get and I need to get to work somehow. Thanks.

- oz

Bambi · 07-15-2013, 12:18 PM

As long as it all stays intact and hasn't been damaged, you'll be perfectly fine. You barely drove the car. If anything just reuse it for now and then replace it with a new gasket for peace of mind if it stresses you out that much.

07-15-2013, 12:06 PM	#1
oscarsx Zilvia Addict Join Date: Apr 2006 Location: SoCal Posts: 697 Trader Rating: (6) Feedback Score: 6 reviews	Re use of intake manifold gasket. I did an emission removal on my s14, long story short. I firmly believe I have a vacuum leak somewhere so I'm planning on removing my manifold. I just installed a new felpro intake gasket with less than 5 miles on the car, if I was to remove my manifold could I re use the gaskets again? I could order new ones but that would then a few days for me to get and I need to get to work somehow. Thanks. - oz __________________ IG: @ozc2jz

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode