Boost limits on the KA

[BlackS14]

I thought the Sr and Ka trannies were one in the same..or was it the bell-ousings....oh well

Most of your "fully built" Ka motors you'll see consist of just some higher in strenght rods and lower comp. pistons. Exceptions are of course Chris Mays car and some others who have fully prepped race motors from Sunbelt, but other than those few. most of your rebuilding is done in the block...pistons and rods.

I've seen upwards of up to 27 psi and above on some Kas who only had the above upgrades as mentioned above. Jay(PSI240SX) runs 20psi daily on his built KA.......nice!!!!

When I do my "rebuild", that's all I'm doing to mine besides for the other precautionary stuff....leakdown test, ect.

...then again, all I want is a good 300 to the wheels andI'll be happy

Bill