MR Coilovers Won't Go Down!!! - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Pacman · 08-09-2005, 02:22 AM

I tried to get the fronts to go down the using the same method as I did the back (took the spanner wrench on the top nut where the spring sits on to get the thread to move down) but the thread didn't want to move down and it was way to hard to get it moving. I don't want to preload the spring and lower it that way so am I going to have to take the macphearson braket off and turn that? I wanted to get rid of the rest of the fender gap before I take it to alignment. Should I just take off the bracket (ugh) or turn it using all my strength (thus denting my adjusting nut)? Heres a pic cause I know this thread is a hard read due to the time of it being posted:

08-09-2005, 02:22 AM	#1
Pacman Zilvia FREAK! Join Date: Sep 2003 Location: Ohio Age: 37 Posts: 1,149 Trader Rating: (1) Feedback Score: 1 reviews	MR Coilovers Won't Go Down!!! I tried to get the fronts to go down the using the same method as I did the back (took the spanner wrench on the top nut where the spring sits on to get the thread to move down) but the thread didn't want to move down and it was way to hard to get it moving. I don't want to preload the spring and lower it that way so am I going to have to take the macphearson braket off and turn that? I wanted to get rid of the rest of the fender gap before I take it to alignment. Should I just take off the bracket (ugh) or turn it using all my strength (thus denting my adjusting nut)? Heres a pic cause I know this thread is a hard read due to the time of it being posted: Last edited by Pacman; 08-09-2005 at 02:43 AM..

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode