|
|
|||||||
| Home | Rules & Guidelines | Register | Member Rides | FAQ | Members List | Social Groups | Calendar | Mark Forums Read |
| Chat General Discussion About The Nissan 240SX and Nissan Z Cars |
 |
|
|
Thread Tools | Display Modes |
|
|
10-12-2005, 10:37 PM
|
#1 |
|
Zilvia Addict
 
Join Date: Jan 2003
Location: Chesapeake, Va
Posts: 609
Trader Rating: (0)
 Feedback Score: 0 reviews
|
Engine Work
When i first got my sr i ripped it apart an wanted to build it. I took it to a shop around here and asked for help
the owner said that since i didnt mark the main end caps in order that i would need to have it align bored. He had that done, or so he says. I later found out that the sr is marked from the factory, needless to say i was pissed. well im not sure if this block was actually align bored or i got suckered. If it was do i need to buy larger main bearings? and if so then is there a way to check and make sure that it was done? thanks for any help you can give me. |
|
|
| Sponsored Links |
|
10-13-2005, 09:28 PM
|
#2 |
|
Zilvia FREAK!
 
Join Date: Jan 2003
Location: rhinelander wisconsin
Age: 42
Posts: 1,465
Trader Rating: (8)
Feedback Score: 8 reviews
|
if i understand right to alighn bore,. they take your caps and block cut some off of both, then rebore the holes for the crank to a stock spec for the holes, kinda like what they do to resize connecting rod big ends.
__________________
 1990 hatch ka24de gt2871r |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
