ohhh yeaaa - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Andrew Bohan · 04-13-2007, 05:36 PM

customer brought us this 240Z with a 327 small block in it. it also has coilovers and a Z32 diff and Q45 rear axles.

he wanted us to build a quiet dual exhaust for it, but there was no room for a pipe on the right side because of the gas tank.
we told him that, and he was sad, but we went ahead and built a quiet single exhaust.
but he really really wanted dual, so we replaced the back floor and installed a fuel cell to make room for the right pipe.

but then he didn't like how the quiet mufflers looked, so we replaced those with straight through magnaflows. now it's louder and looks better.

then he wanted the wiring made better looking. we started that job but found out most of the wiring was garbage, so we got a painless kit and rewired the whole car.
then he wanted autometer gauges installed, so we did that.
while we were in there, he wanted us to cover up the giant hole in the tranny tunnel that whoever put the motor in made. the 4-speed tranny is a side loader so the shifter is about 4" left of centerl

yeaa

04-13-2007, 05:36 PM	#1
Andrew Bohan Post Whore! Join Date: Apr 2003 Location: Ohio Posts: 8,331 Trader Rating: (2) Feedback Score: 2 reviews	ohhh yeaaa customer brought us this 240Z with a 327 small block in it. it also has coilovers and a Z32 diff and Q45 rear axles. he wanted us to build a quiet dual exhaust for it, but there was no room for a pipe on the right side because of the gas tank. we told him that, and he was sad, but we went ahead and built a quiet single exhaust. but he really really wanted dual, so we replaced the back floor and installed a fuel cell to make room for the right pipe. but then he didn't like how the quiet mufflers looked, so we replaced those with straight through magnaflows. now it's louder and looks better. then he wanted the wiring made better looking. we started that job but found out most of the wiring was garbage, so we got a painless kit and rewired the whole car. then he wanted autometer gauges installed, so we did that. while we were in there, he wanted us to cover up the giant hole in the tranny tunnel that whoever put the motor in made. the 4-speed tranny is a side loader so the shifter is about 4" left of centerl yeaa