![]() |
|
Chat General Discussion About The Nissan 240SX and Nissan Z Cars |
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Zilvia Member
![]() |
KA-T help
hey guy im new to turboing a 240sx
i have a 1993 s13 dohc and wanting to turbo it out i wanted to go with the cheap turbo route since im not a baller so help me out guys i was thinking... all this items r from fat boy garage in ebay Bottom mount t25 turbo turbo manifold turbo elbow pipe those 3 items with gasket and screws are $400 and ebay frontmount intercooler with pipings are $200 like oil lines returnlines etc $100 I heard of people just putting this on a stock injectors and stock maf and stock ecu Whould this setup work with stock maf,ecu,injectors and no tuning ? Can i just slap dis on and make it run ? im prob not ganna mess with any boost lvl ill prob have like 7-8 starting right? and if i wanted more power den i could change out all the injectors,ecu,maf right? This is my daily driving car so im not ganna be pushing krxy hp THX for all the help guys |
![]() |
![]() |
Sponsored Links |
![]() |
#3 |
Zilvia Member
![]() |
one word.
BOOM! on a side-note, get 370cc injectors, an enthalpy/jwt/calum etc... and you'll be fine. Last edited by Sidewayzzz; 09-19-2007 at 12:39 PM.. Reason: asdasfsdfasdf |
![]() |
![]() |
![]() |
#4 |
Zilvia FREAK!
![]() |
kould b done
get a boost gauge,walbro pump, fpr/with gauge, get the timing and colder plugs, and make shure its 6 to 7 pounds. over fuel that bitch till you get it tuned~! tuned with 370cc and a safc you kould prolly get close to 230 hp but ull max out your maf but if u want to chang that i would much suggest gettin pistons. stock pistons do not hang!
__________________
fS! vlsd ! slim fans ! hid kits ! lug nuts ! http://www.zilvia.net/f/search.php?d...earchuser=bo2o ^^^click^^^ |
![]() |
![]() |
![]() |
#5 |
Zilvia Addict
![]() |
|
![]() |
![]() |
![]() |
#6 |
seriously.... without a tune you are risking your motor. don't get cheap when it comes the the important stuff. even if you dont wanna spend 500 for enthalpy or jwt you can get an efi specialist rom tune for something like 200. I dont know how good they are but i have a friend that runs one and he swears by it. Without a tune you might as well just throw your motor away since thats what you'll most likely be doing soon after running it without a tune. in the long run it will save time and money.
|
|
![]() |
![]() |
![]() |
Bookmarks |
|
|