Okay, i switched out my clutch and flywheel the other day and ran into some trouble. for one reason or another when i took off my clutch release sleeve, it came off just fine. but after pressing the release bearing onto it, it wouldn't fit back on to the shaft. i ended up taking som sand paper to the inside of the sleeve and shaved it down to where it would fit nicely back on. it's kind of hard to find someone selling just that one part so i was wondering if the KA release sleeve would fit/work with the SR one? anyone come across this problem? any advice is appreciated?
03-24-2009, 02:26 AM
Threaded Mode