|
|
|||||||
| Engine Tech Technical discussion related to all relevant engines such as KA, SR, RB, CA, 2JZ , L24/26/28, VG, VQ, and LSx series. |
 |
|
|
Thread Tools | Display Modes |
09-12-2009, 04:25 PM
|
#1 |
|
Join Date: Jul 2008
Location: San Diego
Age: 40
Posts: 1
Trader Rating: (0)
 Feedback Score: 0 reviews
|
Crankshaft position sensor issues!!!!!!!!!
I have a 5 speed 94.5 240sx (this is a S14) and, the wire harness for the CKP sensor is missing. I need to know exactly where the two wires for the CKP sensor connect to. I was informed that they connect directly to the PCM in pin 53 for power and pin 50 for ground but, i don't know for sure. The pin 53 in the wiring harness for the the ECM is non-exsisting. I am also unsure if I have obd1 or obd2 because, I have both connectors. Can anyone help? [email protected]
Last edited by redsand100; 09-15-2009 at 01:36 AM.. |
|
|
| Sponsored Links |
|
09-12-2009, 04:55 PM
|
#2 |
|
Post Whore!
 
Join Date: Dec 2002
Location: Atlanta
Age: 51
Posts: 13,812
Trader Rating: (12)
 Feedback Score: 12 reviews
|
You can read the FSM, it'll tell you.
The subharness from the CPS to the lower harness has three wires, Is yours missing, or cut off? I'd source the subharness and wire into the lower harness, easier than running back inside.
__________________
FORMERLY R240NA Learn what's really going on and protect your assets now before they're gone forever: www.paypalsucks.com |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
