Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Go Back   Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum > General > Tech Talk

Tech Talk Technical Discussion About The Nissan 240SX and Nissan Z Cars


Reply
 
Thread Tools Display Modes
Old 03-29-2011, 03:05 PM   #1
Josho
Zilvia Junkie
 
Josho's Avatar
 
Join Date: Mar 2010
Location: AL
Posts: 310
Trader Rating: (7)
Josho is an unknown quantity at this point
Feedback Score: 7 reviews
Blacktop running rich/poor after upgrades

Ok here's the situation.. I have a 93 Nissan Silvia originally equipped with a redtop sr20det. The car ran perfect stock. Now I have a s13 Blacktop with a built head, gt2871r turbo, walbro 255, stock injectors, maf and a stock Blacktop ecu. Now obviously the car would run a little rough but it's still driveable. The only problem it gives me is every now and then it'll shut off when I let off the gas and come to a stop.

Ok, so when I purchased the blacktop(already built) I also bought this guys tuned ecu. He had it tuned for the same mods including the turbo. They only mods I was missing was the z32 maf and 850cc injectors(which his ecu was tuned for as well). So I bought a new maf and injectors and installed them and the tuned ecu. With that installed the car cranks up just fine but rins very rough. I can rev it up as high as I want but it breaks up real bad. I swapped my maf with a known good one and it runs the same.. Any suggestions? Could the ecu be bad? I also have a coolant temp sensor out of a redtop, not sure if that matters.

Last edited by Josho; 05-02-2011 at 07:02 PM..
Josho is offline   Reply With Quote
Sponsored Links
Old 03-29-2011, 03:16 PM   #2
Sileighty_85
Post Whore!
 
Sileighty_85's Avatar
 
Join Date: Dec 2006
Location: Misawa, Japan
Posts: 6,815
Trader Rating: (8)
Sileighty_85 is close to perfectionSileighty_85 is close to perfectionSileighty_85 is close to perfectionSileighty_85 is close to perfectionSileighty_85 is close to perfectionSileighty_85 is close to perfectionSileighty_85 is close to perfectionSileighty_85 is close to perfectionSileighty_85 is close to perfectionSileighty_85 is close to perfectionSileighty_85 is close to perfection
Feedback Score: 8 reviews
So your running a Black Top ECU with a Red Top Harness?

Depending on the Black Top ECU, You'll have to repin the ECU harness.

I forgot which one needs to be repinned so just look around here and see
__________________
後輪駆動車1番
1989 Built SR GT2871R -363whp
1998 S14 W/RB25- 250ish (For Now)
1986 SR86 - 200ish
1990 R32 GTR - 320hp
Don't Buy Engines from JDM-Online http://zilvia.net/f/businesses/207457-jdm-online.html
Don't Buy XS-Power or SSAC Shit
Sileighty_85 is offline   Reply With Quote
Old 03-29-2011, 03:24 PM   #3
chetos13
Zilvia Member
 
chetos13's Avatar
 
Join Date: Mar 2008
Location: las vegas, nv
Age: 39
Posts: 206
Trader Rating: (2)
chetos13 is an unknown quantity at this point
Feedback Score: 2 reviews
Send a message via Yahoo to chetos13
fpr or the vac lines check them out fpr might not be getting the correct vacuum
__________________
TEAM ELITE
chetos13 is offline   Reply With Quote
Old 03-30-2011, 07:08 AM   #4
Josho
Zilvia Junkie
 
Josho's Avatar
 
Join Date: Mar 2010
Location: AL
Posts: 310
Trader Rating: (7)
Josho is an unknown quantity at this point
Feedback Score: 7 reviews
I think my ecu and harness setup is fine. I have 2 E5 ecu's. The stock one(which makes the car run pretty decent) and the tuned one(makes the car run like s**t). Could it really be a vac. issue just because I swapped the ecu and added bigger injectors and maf? It would kinda make sense but could someone explain why, if that is the case.
Josho is offline   Reply With Quote
Old 04-01-2011, 06:06 PM   #5
Josho
Zilvia Junkie
 
Josho's Avatar
 
Join Date: Mar 2010
Location: AL
Posts: 310
Trader Rating: (7)
Josho is an unknown quantity at this point
Feedback Score: 7 reviews
My major concern is the ecu. Can anybody atleast rule out the ecu as being the problem?
Josho is offline   Reply With Quote
Old 04-01-2011, 06:26 PM   #6
usdm180sx
Post Whore!
 
usdm180sx's Avatar
 
Join Date: Dec 2005
Location: 562
Posts: 4,807
Trader Rating: (5)
usdm180sx is close to perfectionusdm180sx is close to perfectionusdm180sx is close to perfectionusdm180sx is close to perfectionusdm180sx is close to perfectionusdm180sx is close to perfectionusdm180sx is close to perfectionusdm180sx is close to perfectionusdm180sx is close to perfectionusdm180sx is close to perfectionusdm180sx is close to perfection
Feedback Score: 5 reviews
Send a message via AIM to usdm180sx Send a message via Yahoo to usdm180sx
Get that shit properly tuned with a programmable ecu
__________________
-Norm!

usdm180sx is offline   Reply With Quote
Old 04-01-2011, 06:36 PM   #7
KiLLeR2001
Post Whore!
 
Join Date: Jun 2007
Location: オーランドフロリダ
Posts: 7,955
Trader Rating: (46)
KiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud of
Feedback Score: 46 reviews
Which O2 sensor are you running? If you are using the E5 ECU, you need the fat type sensor.
__________________
KiLLeR2001 is offline   Reply With Quote
Old 04-02-2011, 07:22 AM   #8
Josho
Zilvia Junkie
 
Josho's Avatar
 
Join Date: Mar 2010
Location: AL
Posts: 310
Trader Rating: (7)
Josho is an unknown quantity at this point
Feedback Score: 7 reviews
I have the cross reference o2 sensor. I think it was the TT z32. It's fat.
Josho is offline   Reply With Quote
Old 04-02-2011, 07:54 AM   #9
PoorMans180SX
Zilvia.net Advertiser
 
PoorMans180SX's Avatar
 
Join Date: Nov 2005
Location: Michigan
Age: 37
Posts: 5,616
Trader Rating: (16)
PoorMans180SX is close to perfectionPoorMans180SX is close to perfectionPoorMans180SX is close to perfectionPoorMans180SX is close to perfectionPoorMans180SX is close to perfectionPoorMans180SX is close to perfectionPoorMans180SX is close to perfectionPoorMans180SX is close to perfectionPoorMans180SX is close to perfectionPoorMans180SX is close to perfectionPoorMans180SX is close to perfection
Feedback Score: 16 reviews
Send a message via AIM to PoorMans180SX
How long did you run the car "stock" with the 2871R and at what boost?

Who is the ECU tuned by?
__________________
Build: http://zilvia.net/f/showthread.php?t=643065

Friends don't let friends buy knock-offs.
PoorMans180SX is offline   Reply With Quote
Old 04-02-2011, 08:07 AM   #10
jchrisw85
Leaky Injector
 
jchrisw85's Avatar
 
Join Date: Aug 2010
Location: Clifton, NJ
Age: 39
Posts: 54
Trader Rating: (0)
jchrisw85 is an unknown quantity at this point
Feedback Score: 0 reviews
is your bov recirculated?
jchrisw85 is offline   Reply With Quote
Old 04-02-2011, 08:35 AM   #11
kojiki88
Zilvia Member
 
kojiki88's Avatar
 
Join Date: May 2009
Location: New Mexico
Age: 37
Posts: 245
Trader Rating: (4)
kojiki88 is an unknown quantity at this point
Feedback Score: 4 reviews
Quote:
Originally Posted by Sileighty_85 View Post
So your running a Black Top ECU with a Red Top Harness?

Depending on the Black Top ECU, You'll have to repin the ECU harness.

I forgot which one needs to be repinned so just look around here and see
I know you have repin the Type X Harness if you want to use another ECU that is not a Type X. Could be the tune in the ECU, Not every Motor runs the same even with Similar builds. GL
kojiki88 is offline   Reply With Quote
Old 04-03-2011, 01:42 AM   #12
Josho
Zilvia Junkie
 
Josho's Avatar
 
Join Date: Mar 2010
Location: AL
Posts: 310
Trader Rating: (7)
Josho is an unknown quantity at this point
Feedback Score: 7 reviews
ecu is an enthalpy tune.. I think. I'll double check that.

My bov in not recirculated.

As for the tune; I bought the motor from him aswell. We had the same turbo only his had a bigger exhaust housing. Other then that, everything was the exact same thing.
Josho is offline   Reply With Quote
Old 04-14-2011, 05:29 PM   #13
Josho
Zilvia Junkie
 
Josho's Avatar
 
Join Date: Mar 2010
Location: AL
Posts: 310
Trader Rating: (7)
Josho is an unknown quantity at this point
Feedback Score: 7 reviews
hoping to get this situation figuered out this weekend. Anymore suggestions would be greatly appreciated.
Josho is offline   Reply With Quote
Old 05-02-2011, 07:04 PM   #14
Josho
Zilvia Junkie
 
Josho's Avatar
 
Join Date: Mar 2010
Location: AL
Posts: 310
Trader Rating: (7)
Josho is an unknown quantity at this point
Feedback Score: 7 reviews
Upated with video
Josho is offline   Reply With Quote
Reply

Bookmarks



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 09:27 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vB.Sponsors
Copyright ? 1998 - 2022, Zilvia.net