Is there a detail tutorial to remove tail lights from a s13 hatch?

[Hanzi]

Is there any detailed video that go step by step on how to remove the tail lights of a s13 hatch?

[innovation]

open trunk, remove lining covering the tail lights. Proceed to disconnect plug from lights. Unscrew bolts holding down lights. Remove tail lights. DONE =)

[cardoza]

Yeah, everything is pretty easily seen. If you pull on the light and it doesn't come out, you forgot something.

[Ilya]

If you removed everything and it still doesnt come out, keep pulling, its the black rubber sealer stuff holding it in, its pretty sticky, but not unmanagable. Make sure you have new black sealer stuff aka butyl rubber seal ready for when you reinstall

[charat]

yeah, its in the FSM.

[rat240]

check the FAQ the thread tittle is some thing like fixing a leaking hatch or water getting in your trunk

[Bushido]

take the center taillight out first, then the left and right.

no need to undo the lower bolts that hold the metal under taillight trim

[bc.]

Originally Posted by Hanzi

Is there any detailed video that go step by step on how to remove the tail lights of a s13 hatch?

no____________

[bookoo]

Originally Posted by Bushido

take the center taillight out first, then the left and right.

no need to undo the lower bolts that hold the metal under taillight trim

This, make sure to take the center garnish out or you will crack/break it.

[ballinnmiami240sx]

lol you should run away from a 240 if you need a video to take off the tail lights

[olah.inc]

Originally Posted by ballinnmiami240sx

lol you should run away from a 240 if you need a video to take off the tail lights

shots fired

1) remove center panel
2) remove tail lights
3) do it on a hot day so that the sealant loosens

done and done

[sr20sean]

come on guys help the guy out.

1) open trunk
2) remove liner
3) unplug lights
4) theres a few clips that are holding the trunk release that are clipped over the end of a few of the nuts.
5) remove the 8mm nuts that hold in the center garnish
6) remove center garnish
7) remove the 8mm nuts that hold the side tail lights
8) remove tail light (you will have a bit of a rough time being that there is quite a bit of that rubber sealant around them holding them in. just wiggle)
9) repeat on the other side.
10) you are finished.

install:
1) whole thing above just backwards. before installing make sure to use new rubber sealant or they will leak.

[NissanEnthus]

^2nd this....Its super easy, really....Seeing that your 17 your doing the right thing by gathering knowledge first, but honestly only you need is a bit of confidence too

[bladetech8]

Searching works wonders aye?

http://zilvia.net/f/archive-faqs/103...taillamps.html

Pictures and step-by-step disassembly.. Follow it backwards for reassembly.

[Tantwoforty]

240sx FSM, Full Service Manuals, S13, S14, KA24E, KA24DE : 240sx General Discussion