Bee*r rev limiter problem - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Jersthecool · 12-24-2011, 09:44 PM

Alright so I'm following the N02 diagram for an sr20 and spliced into all the wires then connected the appropriate colors to the correct wires, fired it up and it acts exactly the same as if I didn't have it installed. No light or anything even tried reversing the green and yellow wire and it still starts up and does the same thing. However I noticed when the car shuts off the red light will flash once quickly so I know it's getting power. I did cut the grey wire not any other ones. The only thing is I didn't connect the white wire to the ebrake cable but I understand the rev 1 knob should still work without the ebrake one connected. Any ideas?

12-24-2011, 09:44 PM	#1
Jersthecool Zilvia Junkie Join Date: Jul 2010 Location: Calgary, Canada Posts: 342 Trader Rating: (0) Feedback Score: 0 reviews	*Beer rev limiter problem** Alright so I'm following the N02 diagram for an sr20 and spliced into all the wires then connected the appropriate colors to the correct wires, fired it up and it acts exactly the same as if I didn't have it installed. No light or anything even tried reversing the green and yellow wire and it still starts up and does the same thing. However I noticed when the car shuts off the red light will flash once quickly so I know it's getting power. I did cut the grey wire not any other ones. The only thing is I didn't connect the white wire to the ebrake cable but I understand the rev 1 knob should still work without the ebrake one connected. Any ideas?