VA F/S/T SR20 Black top long block looking for cash,wheels,etc. - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

MSTRMND · 12-27-2012, 05:34 AM

Originally got this motor for my fiances car but she ended up getting an s14 with an sr already in it, so this is for sale. I bought it originally with a spun bearing, but replaced the crank and bearings due to the fact I had a fresh from Japan short block laying in my garage with no use.

Replaced crank/bearings
Replaced oil pump
Replaced all exhaust studs
Converted intake manifold to m8 studs/ locking nuts
New intake manifold gasket
New thermostat
New spark plugs
New rear main seal
New front oil seal
New exhaust gasket
Complete intake manifold w/ sensors and injectors
Coil packs
Freshly painted valve cover (soon)
Good CAS included
Mint oem flywheel
Mint exedy or clutch
New pilot bushing
Tubular stainless manifold
Stainless dump tube
Solid non-smoking T25
Good alternator
Good starter
Good P/S pump
Tensioner, guides, chain inspected for wear or damage
Uncut harness
ECU

All sludge/oil/ deposits were cleaned out of this motor and the oil pickup screen was thoroughly cleaned as well until like new.

I've built numerous motors including my current RWD neo vvl monster. So you can trust you're getting a solid swap, it was intended to go in my fiances car after all.

Trades:
Nice wheels
S14 parts

$800

5402878161 for pics

Chris

12-27-2012, 05:34 AM	#1
MSTRMND Zilvia Member Join Date: Jun 2011 Location: Fredericksburg,VA Age: 34 Posts: 178 Trader Rating: (3) Feedback Score: 3 reviews	F/S/T SR20 Black top long block looking for cash,wheels,etc. Originally got this motor for my fiances car but she ended up getting an s14 with an sr already in it, so this is for sale. I bought it originally with a spun bearing, but replaced the crank and bearings due to the fact I had a fresh from Japan short block laying in my garage with no use. Replaced crank/bearings Replaced oil pump Replaced all exhaust studs Converted intake manifold to m8 studs/ locking nuts New intake manifold gasket New thermostat New spark plugs New rear main seal New front oil seal New exhaust gasket Complete intake manifold w/ sensors and injectors Coil packs Freshly painted valve cover (soon) Good CAS included Mint oem flywheel Mint exedy or clutch New pilot bushing Tubular stainless manifold Stainless dump tube Solid non-smoking T25 Good alternator Good starter Good P/S pump Tensioner, guides, chain inspected for wear or damage Uncut harness ECU All sludge/oil/ deposits were cleaned out of this motor and the oil pickup screen was thoroughly cleaned as well until like new. I've built numerous motors including my current RWD neo vvl monster. So you can trust you're getting a solid swap, it was intended to go in my fiances car after all. Trades: Nice wheels S14 parts $800 5402878161 for pics Chris Last edited by MSTRMND; 01-03-2013 at 06:41 PM..