Did you say ball joints? - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

fishstix · 07-22-2013, 08:02 PM

I need new ball joints , probably all four corners. I've been looking at the ones for roll center adjust but not convinced they are a good investment. Plus instead of spending the big bucks on one of these sets I have thought of buying a set of ball joints from bicknell race products and the collars they press into and re fabing some stock LAC so those BJs sit higher, how ever how can I figure out wether or not the taper on the shaft will work? Any ideas? Know anyone to do the same or similar?

Here is the link. http://bicknellracingproducts.com/do..._catalog/3.pdf

Junkyard diving tomorrow!

07-22-2013, 08:02 PM	#1
fishstix Join Date: Jun 2013 Location: sacramento Age: 38 Posts: 31 Trader Rating: (0) Feedback Score: 0 reviews	Did you say ball joints? I need new ball joints , probably all four corners. I've been looking at the ones for roll center adjust but not convinced they are a good investment. Plus instead of spending the big bucks on one of these sets I have thought of buying a set of ball joints from bicknell race products and the collars they press into and re fabing some stock LAC so those BJs sit higher, how ever how can I figure out wether or not the taper on the shaft will work? Any ideas? Know anyone to do the same or similar? Here is the link. http://bicknellracingproducts.com/do..._catalog/3.pdf Junkyard diving tomorrow! Last edited by fishstix; 07-23-2013 at 01:57 AM..