Selling my s14 w sr How much woud you pay? - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Danger_Dorn · 07-22-2013, 11:14 AM

S14 240sx Rebuilt SR20DET 1k Miles - $10000 (Jacksonville)
'95 S14 with SR20det Redtop. I bought the car stock and have 99% work myself. I have put about 12k into this car. I have had the car for about 2 years now and runs well. I'm only selling the car because I have a baby on the way and this is not the best family car.

Engine: Motor has 1k miles and was rebuilt by East Coast Performance here in Jacksonville and have had no problems with it. It has new main and rod bearings, thrust washers, piston rings, ARP rod studs, ARP head studs, Cosworth 1.8mm metal hg, new valve shims and guides, rocker arm stoppers, all new main seals and gaskets, block and head were decked along with oil pump cover, new timing chain kit w/ tensioner, 2 row aluminum radiator, fmic, T25 turbo, HKS 12psi internal WG actuator, optima redtop battery relocation to passenger side trunk, wiring specialties upper and lower harness, walbro 255lph fp all new vac and coolant lines, cleaned injectors, JGS Motor and Trans mounts, Energy suspension subframe bushings, larger oil pan, ISIS/B&M short shifter.

Interior is like a 7/10. It's all there but the seats have some stains on them and the typical dash crack

Body is like a 5/10. It has some body damage on the rear driver quarter panel. Its not bad it could be fixed with a come along and some bondo I just dont have time or resources to do it. The trunk still shuts. The body is spray painted flat black and need a paintjob unless you don't mind. Chip in the windshield.

I have not had power steering converted over to this chassis/motor so it doesnt have it. I have all of the AC stuff it just needs to be installed.

I just had new Primewell PZ900 tires put on less than 1k miles ago. Fully adjustable Function and Form 2 coilovers, full 3" exhaust, XXR 525 17" rims 225 in front 245 in back. Radio with JL audio speakers, AEM UEGO wideband, oil pressure, boost, and water temp guage, HID's, 5 speed manual with no problems, hood pins (stock latch failed).

I cant think of anything else at the moment. Pictures to come soon. I would like 10k OBO. 6083592768 Text is preferred, calling works too.

WristWork · 07-22-2013, 11:20 AM

4 Thousand

jr_ss · 07-22-2013, 12:09 PM

You're dreaming if you think anyone is going to pay anything close to 10k, let alone 6k. No offense, but it's a rattle canned, beat to shit S14. If it wasn't in "primer" and didn't have a huge wall tap on the rear quarter, you'd probably get close to what you "want".

That's also like Kingalton asking 17k for an S14 SR swapped Kouki. No one is going to pay that.

Maiku240sxS14 · 07-22-2013, 12:17 PM

"She's ugly as hell but she's mine."

Danger_Dorn · 07-22-2013, 12:43 PM

thanks for the input guys. I dont actually expect 10k out of it. I was guessing between 5-7k. All it needs is bodywork.

zooopreme · 07-22-2013, 12:49 PM

Quote:

Originally Posted by Danger_Dorn

All it needs is bodywork.

riiiiiiight...

That's what they all say...

***enkei2k*** · 07-22-2013, 03:21 PM

Put it in the market place to find out. That's all you have to do to dictate what a good price is.

body of the OP looks like a FS thread = wrong section =

07-22-2013, 11:14 AM	#1
Danger_Dorn Zilvia Member Join Date: Oct 2012 Location: Jacksonville NC Age: 33 Posts: 265 Trader Rating: (0) Feedback Score: 0 reviews	Selling my s14 w sr How much woud you pay? S14 240sx Rebuilt SR20DET 1k Miles - $10000 (Jacksonville) '95 S14 with SR20det Redtop. I bought the car stock and have 99% work myself. I have put about 12k into this car. I have had the car for about 2 years now and runs well. I'm only selling the car because I have a baby on the way and this is not the best family car. Engine: Motor has 1k miles and was rebuilt by East Coast Performance here in Jacksonville and have had no problems with it. It has new main and rod bearings, thrust washers, piston rings, ARP rod studs, ARP head studs, Cosworth 1.8mm metal hg, new valve shims and guides, rocker arm stoppers, all new main seals and gaskets, block and head were decked along with oil pump cover, new timing chain kit w/ tensioner, 2 row aluminum radiator, fmic, T25 turbo, HKS 12psi internal WG actuator, optima redtop battery relocation to passenger side trunk, wiring specialties upper and lower harness, walbro 255lph fp all new vac and coolant lines, cleaned injectors, JGS Motor and Trans mounts, Energy suspension subframe bushings, larger oil pan, ISIS/B&M short shifter. Interior is like a 7/10. It's all there but the seats have some stains on them and the typical dash crack Body is like a 5/10. It has some body damage on the rear driver quarter panel. Its not bad it could be fixed with a come along and some bondo I just dont have time or resources to do it. The trunk still shuts. The body is spray painted flat black and need a paintjob unless you don't mind. Chip in the windshield. I have not had power steering converted over to this chassis/motor so it doesnt have it. I have all of the AC stuff it just needs to be installed. I just had new Primewell PZ900 tires put on less than 1k miles ago. Fully adjustable Function and Form 2 coilovers, full 3" exhaust, XXR 525 17" rims 225 in front 245 in back. Radio with JL audio speakers, AEM UEGO wideband, oil pressure, boost, and water temp guage, HID's, 5 speed manual with no problems, hood pins (stock latch failed). I cant think of anything else at the moment. Pictures to come soon. I would like 10k OBO. 6083592768 Text is preferred, calling works too.

07-22-2013, 12:09 PM	#3
jr_ss Post Whore! Join Date: Dec 2005 Location: Pa Posts: 6,415 Trader Rating: (35) Feedback Score: 35 reviews	You're dreaming if you think anyone is going to pay anything close to 10k, let alone 6k. No offense, but it's a rattle canned, beat to shit S14. If it wasn't in "primer" and didn't have a huge wall tap on the rear quarter, you'd probably get close to what you "want". That's also like Kingalton asking 17k for an S14 SR swapped Kouki. No one is going to pay that. __________________ My SR20VET Does your VTC gear rattle in your S14/15 SR? PM me.

07-22-2013, 03:21 PM	#7
*enkei2k* Super Moderator Join Date: Jul 2007 Location: over the river and through the woods Age: 40 Posts: 7,160 Trader Rating: (29) Feedback Score: 29 reviews	Put it in the market place to find out. That's all you have to do to dictate what a good price is. body of the OP looks like a FS thread = wrong section = __________________ Ask enkei2k xquizitditz

07-22-2013, 11:20 AM	#2
WristWork Zilvia Addict Join Date: Jul 2012 Location: N/A Posts: 742 Trader Rating: (12) Feedback Score: 12 reviews	4 Thousand

07-22-2013, 12:17 PM	#4
Maiku240sxS14 Nissanaholic! Join Date: Jul 2007 Location: LA Posts: 2,019 Trader Rating: (37) Feedback Score: 37 reviews	"She's ugly as hell but she's mine."

07-22-2013, 12:43 PM	#5
Danger_Dorn Zilvia Member Join Date: Oct 2012 Location: Jacksonville NC Age: 33 Posts: 265 Trader Rating: (0) Feedback Score: 0 reviews	thanks for the input guys. I dont actually expect 10k out of it. I was guessing between 5-7k. All it needs is bodywork.