Slotting camber plates... - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

t3chnique · 08-19-2013, 12:13 AM

So I would like to slot my camber plates for more negative, they are the typical 1/4" thick aluminum camber plates that Megan/BC/K-Sport use.

What would be the best tool to use to notch the plates, mainly the larger middle hole where the top nut is (read: where you adjust the strut dampening to hard or soft) ?

I'm not looking to slot the upper hole in the bottom mount. A jigsaw and dremel are at my disposal.

TIA

jr_ss · 08-19-2013, 05:27 AM

Send them to a machine shop to be milled.

Croustibat · 08-19-2013, 05:40 AM

Dont slot them. The bearing that is right under cannot take more angle than what you already have (i dont think it can handle what you currently have, actually)

08-19-2013, 12:13 AM	#1
t3chnique Leaky Injector Join Date: Aug 2010 Location: West Coast Posts: 90 Trader Rating: (-1) Feedback Score: -1 reviews	Slotting camber plates... So I would like to slot my camber plates for more negative, they are the typical 1/4" thick aluminum camber plates that Megan/BC/K-Sport use. What would be the best tool to use to notch the plates, mainly the larger middle hole where the top nut is (read: where you adjust the strut dampening to hard or soft) ? I'm not looking to slot the upper hole in the bottom mount. A jigsaw and dremel are at my disposal. TIA

08-19-2013, 05:27 AM	#2
jr_ss Post Whore! Join Date: Dec 2005 Location: Pa Posts: 6,415 Trader Rating: (35) Feedback Score: 35 reviews	Send them to a machine shop to be milled. __________________ My SR20VET Does your VTC gear rattle in your S14/15 SR? PM me.

08-19-2013, 05:40 AM	#3
Croustibat Nissanaholic! Join Date: Aug 2011 Location: France - Toulouse Age: 44 Posts: 1,851 Trader Rating: (0) Feedback Score: 0 reviews	Dont slot them. The bearing that is right under cannot take more angle than what you already have (i dont think it can handle what you currently have, actually)