![]() |
|
For Sale Items Post items for sale here. ABSOLUTELY NO COMMERCIAL SALES. |
|
Thread Tools | Display Modes |
![]() |
#1 |
![]() This is not your average weekend SR20det swapped 240sx, it is 3 year ground up resto-mod build. She was stripped down to a bare chassis where all rust was removed and replaced with fresh metal, and any surface rust was wire wheeled and treated with POR-15. She was originally a maroon hatch, but is now covered in Lexis Metallic Burnt Micah (engine bay, door jambs, everything). She was then painstakingly built back up with new parts or the best pieces of 3 different 240sx’s.
She has been my daily driver for the last 2 years and 20,000 miles. Extremely reliable especially considering the amount of modifications, I drove it to Ohio and back at 32 mpg. This has been my baby, never taken to a track, beat on or abused. All fluids are premium synthetic. I’m currently running 16 psi on the turbo, the setup is good to 18 psi and can be turned up to over 350 hp. But for street use it is still a beast at 16 psi and pure joy to drive. I have over $20,000 invested with thousands of hours of labor involved. Then 9 months ago she was rear ended and totaled, the chassis was bent from the accident. I repaired the body and have been driving it since, but now it’s time to part it out. I will continue to drive the car until the power train sells, (I WILL NOT START PARTING THE CAR UNTILL THE ENGINE SELLS). The power train buyer has first dibs on ALL parts, I can sell them a complete turnkey swap from air filter to exhaust tip including engine management. The price will greatly depend on what parts go with it, parts that I will not separate from the engine are listed with it. When I installed the head gasket and studs you could still see the hone marks in the cylinder walls and the factory paint mark on the timing chain, this is a very clean low mileage engine that has not been abused and ran with premium synthetics. I am listing this on multiple forums and on Craig’s List for that reason I will answer questions through my email only [email protected] , the powertrain will be available 1 week after a deposit is received. At that point I will update all listings that the partout has begun and will start taking payments and delivering parts. I am located in Carrollton Virginia and I am willing to ship in the US only, local pickup is available and preferred. The following is the list of parts (I’m probably missing some). Body Factory Silvia front end with triple beam projector headlights and Silvia center grill. $1000 Chassis Rebuilt steering rack $150 Aluminum steering bushing $15 Aluminum sub-frame bushings $65 Oversized sway bars front and rear $125 Megan racing strut bars front and rear $75 Brakes 300zx master cylinder & Booster $125 Q45 front and rear calipers, SS braided lines, and Cross drilled and slotted zinc plated rotors $175 16x7 Enkei’s wrapped in 225/50 Dunlop Direzza’s (tires are done) $300 Power train Custom aluminum 1 piece driveshaft $250 180SX limited slip rear diff $175 Interior Mickey ears steering column gauge pod $15 Battery relocation kit $25 Viper alarm with turbo timer and remote start $50 Uncracked black Dashboard $200 Engine Black Top SR20det (approximately 35K) SR 5spd with Act HD sprung clutch, Cosworth Metal Head gasket, ARP head studs, ISIS Rocker stoppers, Greddy oil pan, & Greddy blue aluminum under drive pulleys $3,500 Jim Wolf tuned ECU flow matched to the installed 555 injectors $600 Garrett GT2560R ball bearing turbo $700 HKS adjustable waste gate actuator $200 Tial 60mm blue blow off (recirculated) $400 SS braided turbo lines $75 Tomei turbo elbow $125 Greddy 3” downpipe $125 Apexi 3” to dual 2-1/2” N1 Exhaust with test pipe $450 Walbro 255 fuel pump $50 Nismo air filter (painted to match the car) $50 Polished suction kit $185 300zx MAFS $50 Godspeed oversized polished aluminum FMIC with stainless steel mounts & Polished aluminum intercooler piping & Blue silicone hoses $175 $175 Godspeed polished aluminum radiator with Twin slim line electric fans & Blue silicone hoses $175 Extra Parts for sale S13 Convertible leather rear seats $150 S13 Ka Fidanza Flywheel, Exedy Pressure plate with 6 Puck sprung clutch (NEW) $350 S13 Rear Tail lights (2 Driver, 1 Passenger) $20 each SR20DET Fuel Rail with purple injectors $175 Spare Blacktop SR20DET engine (for rebuild/parts) $1,000 Walbro 255 fuel pump $50 S13 Blacktop T25 Turbo $175 Off brand T28 Turbo (needs rebuilt) $50 S13 Blacktop factory turbo oil/coolant lines $35 $300ZX Brake master $65 |
|
![]() |
![]() |
Sponsored Links |
Bookmarks |
|
|