PA 400hp turn key sr20 swap

[mattsil80wis]

Name: Matt
Contact: PM
Location: Bethlehem, PA
Price: $5,000 obo
Shipping: NO
Trades: not unless you have a lsx/t56 and cash (depending)
Parting out: NO

Car made 401hp/323tq before retune, engine is still in car and starts and runs fine. I am sure there is more im forgetting, but if you have questions just ask. I have had no problems with this car, just want to go v8. Motor probably has 12,xxx miles on it, but cylinder walls still have cross hatching. It is everything to take it out of my car and drop it right into your s13 and start it up and drive, i mean everything.

Engine:

CP Pistons 8.5:1 swain coated skirts
Apexi 1.1mm Headgasket
Greddy Oil Pan
JWT S3 cams
Greddy Rocker arm stoppers
ARP head studs

Turbo:

GT2871r .64
Stock Exhaust Manifold with Cody Ace welded external gate, swain coated and extrude honed.
Tial 38mm Wastegate
Greddy J pipe

Drivetrain:

Spec Stage 3+ Clutch/Pressure Plate
JWT Lightened Flywheel
Driveshaft Shop 1 piece driveshaft
stock sr20det 5 speed trans
B&M short shifter

Other mis:

Wiring Specialist Wiring Harness
Freddy Intake Manifold
Z32 Mass air flow sensor
72lb injectors with resistors
JGY fuel rail
Nismo Type B Fuel Pressure Regulator
Greddy Front Mount intercooler
JWT tuned ECU (retuned, 2 step, meth injection)
Greddy Catch Can
Drift Freaq Motor Mounts
Koyo Radiator
Altima Fans (may keep them)
Quest Alternator with Cody Ace bracket
Greddy Profec B boost controller
Greddy Intake Filter
Greddy BOV

[mattsil80wis]

Let's get this sold so I can go turbo v8

[street_sleeper]

If no hits for the full setup, is there a possible part out? I'm interested in the motor

[S13slida]

Would you sell the complete swap for 4k shipped? if so PM me i just dont have the full 5k

[mattsil80wis]

Bump this to the top

[240knockout]

interested in cams if you ever decide to part.

[jollyroger927]

Interested in a few things if you decide to part. Free bump

[powermymotor]

Damn 400hp nice

[mattsil80wis]

We will give this one last shot. Let's see if we can do this

[ehhhregartless]

Somebody step to the plate! I modeled about 90% of this setup in my coupe and it rips!

[Kingtal0n]

That dyno- do you have the air fuels?

Are you sure the boost was the same on both?

Because if the gas was the same, and boost was the same, all thats left is... timing.

[codyace]

Originally Posted by Kingtal0n

That dyno- do you have the air fuels?

Are you sure the boost was the same on both?

Because if the gas was the same, and boost was the same, all thats left is... timing.

Boost was 100% the same, as I changed the ECU between the runs.

Timing is different between both ECU's across the board, while AFR is the same.



For everyone else, I'll vouch for the setup and car as it's a great running car.

This is a super fair deal, as you can't even remotely buy the bolt on parts used for that price, let alone get a strong running engine with it.

[blueshark123]

I have a complete ls1 t56 drop out still in the trans am with 58kmiles lmk if interested (not trading)

[mattsil80wis]

Originally Posted by blueshark123

I have a complete ls1 t56 drop out still in the trans am with 58kmiles lmk if interested (not trading)

If this sells ill def look to buy it

[mattsil80wis]

Back on the market

[KameTrick]

Interested, PM sent. Feel free to reply by PM or to my username at gmail.