IL s13 Blacktop motorset with goodies! - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

leedrift · 07-26-2013, 01:08 AM

Complete motorset originally from JDMHookup. Mileage unknown, but From what I remember the PO saying and what I drove it it can't be anything over 80k. Wired for an 89-90.

-Polished valve cover that could see some more elbow grease
-Clear CAS cover. Watch that bitch spin!
-Greddy rocker arm stoppers
-Greddy oil relocation and I'll include the bosch filter that has like 600 miles on it
-Megan short throw
-HG replaced about 1.5k ago along with all the gaskets corresponding with that job, head was inspected/cleaned
-Nismo thermostat
-Fancy oil cap
-New pcv valve
-I can't remember the brand but it's a good 6 puck clutch. Stiffer than your pp at the strip club. Might also have a lightweight flywheel too if I remember right. I'm going to pull the trans off in the next few days and confirm all this.

Ran great, solid idle. The only problem with it is the seals are gone on the turbo. I'll be including an entire t25 take-off including the manifold, o2 housing, etc. I have no idea if it's good but I was told it was by the guy who I got it from it is and I trust him. Minimal shaft play from what I can tell. I'll also be including a new manifold gasket. ECU and ignitor chip included. The plugs for the ignitor were relocated near the ecu plug on the harness so it's inside the car. Crank pulley has a little chip. Two holes on the oil relocation will need to be plugged as they had the sending units in them for my gauges. I may find some bolts to put in them.

Video driving it about 2 weeks ago. The only time it got driven after this was to the garage to pull the motor. I borrowed the go pro and had to use the head mount. Don't judge me haha-

S13 sr drive - YouTube

PRICE- 1700 Picked up in Canton IL. I feel that's more than reasonable seeing as the motorset alone from jdmhookup is going for 2200.

leedrift · 07-28-2013, 06:57 PM

Bump bump bump

Poizen Bastard · 07-28-2013, 09:12 PM

How much for the whole setup?

leedrift · 07-29-2013, 07:55 PM

http://zilvia.net/f/sale-items/52926...t-goodies.html

Your answer is in that^

leedrift · 08-06-2013, 01:52 PM

1500 this week only. until 8/11.

Theworm · 08-06-2013, 02:14 PM

Pm'd you but found my answers the thread. I'm sure you'll still pm me back

PoorMans180SX · 08-06-2013, 07:18 PM

This is a great deal!

xBtony · 08-07-2013, 01:44 AM

Wish you were in cali, this is exactly the deal I'm looking for.

leedrift · 08-08-2013, 11:27 PM

Me too, It'd be sold by now, and we could cruise our boxes together haha (I'm toastyrs_40 on CxB)

BxLumpy · 08-09-2013, 09:31 AM

this might be a long shot but would you be willing to ship?

leedrift · 08-09-2013, 10:40 AM

If you can find a company to come and get it, and pay for all of it sure. as long as I get 1500 in my pocket, I could care less what happens with it lol. But I'm not doing any research on finding a company, nor prepping it for shipping. You would have to find a company that will come to my house and take it from there. Unless you want to pay for my time.

Poizen Bastard · 01-17-2014, 09:52 AM

Do you still have this SR available?

Sent from my iPad using Tapatalk

07-26-2013, 01:08 AM	#1
leedrift Zilvia Junkie Join Date: Jul 2008 Location: IL Posts: 302 Trader Rating: (4) Feedback Score: 4 reviews	s13 Blacktop motorset with goodies! Complete motorset originally from JDMHookup. Mileage unknown, but From what I remember the PO saying and what I drove it it can't be anything over 80k. Wired for an 89-90. -Polished valve cover that could see some more elbow grease -Clear CAS cover. Watch that bitch spin! -Greddy rocker arm stoppers -Greddy oil relocation and I'll include the bosch filter that has like 600 miles on it -Megan short throw -HG replaced about 1.5k ago along with all the gaskets corresponding with that job, head was inspected/cleaned -Nismo thermostat -Fancy oil cap -New pcv valve -I can't remember the brand but it's a good 6 puck clutch. Stiffer than your pp at the strip club. Might also have a lightweight flywheel too if I remember right. I'm going to pull the trans off in the next few days and confirm all this. Ran great, solid idle. The only problem with it is the seals are gone on the turbo. I'll be including an entire t25 take-off including the manifold, o2 housing, etc. I have no idea if it's good but I was told it was by the guy who I got it from it is and I trust him. Minimal shaft play from what I can tell. I'll also be including a new manifold gasket. ECU and ignitor chip included. The plugs for the ignitor were relocated near the ecu plug on the harness so it's inside the car. Crank pulley has a little chip. Two holes on the oil relocation will need to be plugged as they had the sending units in them for my gauges. I may find some bolts to put in them. Video driving it about 2 weeks ago. The only time it got driven after this was to the garage to pull the motor. I borrowed the go pro and had to use the head mount. Don't judge me haha- S13 sr drive - YouTube PRICE- 1700 Picked up in Canton IL. I feel that's more than reasonable seeing as the motorset alone from jdmhookup is going for 2200.

08-06-2013, 07:18 PM	#7
PoorMans180SX Zilvia.net Advertiser Join Date: Nov 2005 Location: Michigan Age: 37 Posts: 5,616 Trader Rating: (16) Rides Gallery: PoorMans180SX Feedback Score: 16 reviews	This is a great deal! __________________ Build: http://zilvia.net/f/showthread.php?t=643065 Friends don't let friends buy knock-offs.

07-28-2013, 06:57 PM	#2
leedrift Zilvia Junkie Join Date: Jul 2008 Location: IL Posts: 302 Trader Rating: (4) Feedback Score: 4 reviews	Bump bump bump

07-28-2013, 09:12 PM	#3
Poizen Bastard Join Date: Apr 2013 Location: San Diego Age: 35 Posts: 29 Trader Rating: (0) Feedback Score: 0 reviews	How much for the whole setup?

07-29-2013, 07:55 PM	#4
leedrift Zilvia Junkie Join Date: Jul 2008 Location: IL Posts: 302 Trader Rating: (4) Feedback Score: 4 reviews	http://zilvia.net/f/sale-items/52926...t-goodies.html Your answer is in that^

08-06-2013, 01:52 PM	#5
leedrift Zilvia Junkie Join Date: Jul 2008 Location: IL Posts: 302 Trader Rating: (4) Feedback Score: 4 reviews	1500 this week only. until 8/11.

08-06-2013, 02:14 PM	#6
Theworm Leaky Injector Join Date: Oct 2011 Location: Iowa Age: 40 Posts: 63 Trader Rating: (0) Feedback Score: 0 reviews	Pm'd you but found my answers the thread. I'm sure you'll still pm me back

08-08-2013, 11:27 PM	#9
leedrift Zilvia Junkie Join Date: Jul 2008 Location: IL Posts: 302 Trader Rating: (4) Feedback Score: 4 reviews	Me too, It'd be sold by now, and we could cruise our boxes together haha (I'm toastyrs_40 on CxB)

08-09-2013, 09:31 AM	#10
BxLumpy Leaky Injector Join Date: Apr 2010 Location: washington Age: 35 Posts: 90 Trader Rating: (0) Feedback Score: 0 reviews	this might be a long shot but would you be willing to ship?

08-09-2013, 10:40 AM	#11
leedrift Zilvia Junkie Join Date: Jul 2008 Location: IL Posts: 302 Trader Rating: (4) Feedback Score: 4 reviews	If you can find a company to come and get it, and pay for all of it sure. as long as I get 1500 in my pocket, I could care less what happens with it lol. But I'm not doing any research on finding a company, nor prepping it for shipping. You would have to find a company that will come to my house and take it from there. Unless you want to pay for my time.

01-17-2014, 09:52 AM	#12
Poizen Bastard Join Date: Apr 2013 Location: San Diego Age: 35 Posts: 29 Trader Rating: (0) Feedback Score: 0 reviews	Do you still have this SR available? Sent from my iPad using Tapatalk