Need some measurements: - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

giant killer · 03-29-2017, 04:41 PM

I have multiple S13 MT's in my parts pile.. I am getting things together to MT swap my 96 auto.. I need to stay OBD2 compliant so I'll be drilling a hole in the bell housing per the good thread that floats around on the topic.. I've stolen the following picture from said thread.. i think it was on nico..

anyways, I need a location to drill the hole for the OBD2 crank sensor. I'm assuming that I can get the "in and out" measurement from the center line of the flywheel (that is what it reads correct? or is there a part I'm missing?) measured from the block/plate..

From pictures it looks like it doesn't really matter where on the pad "up or down" but that would be my question..

I will look at scaling off an image from the internet.. but if someone had an OBD2 KA bellhousing available to measure it would be rad.

Thanks dewds and dewdettes.

03-29-2017, 04:41 PM	#1
giant killer Leaky Injector Join Date: Sep 2003 Location: CO Age: 41 Posts: 102 Trader Rating: (0) Feedback Score: 0 reviews	Need some measurements: I have multiple S13 MT's in my parts pile.. I am getting things together to MT swap my 96 auto.. I need to stay OBD2 compliant so I'll be drilling a hole in the bell housing per the good thread that floats around on the topic.. I've stolen the following picture from said thread.. i think it was on nico.. anyways, I need a location to drill the hole for the OBD2 crank sensor. I'm assuming that I can get the "in and out" measurement from the center line of the flywheel (that is what it reads correct? or is there a part I'm missing?) measured from the block/plate.. From pictures it looks like it doesn't really matter where on the pad "up or down" but that would be my question.. I will look at scaling off an image from the internet.. but if someone had an OBD2 KA bellhousing available to measure it would be rad. Thanks dewds and dewdettes.