![]() |
|
Tech Talk Technical Discussion About The Nissan 240SX and Nissan Z Cars |
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Zilvia Junkie
![]() Join Date: Jan 2005
Location: philadelphia, pa
Age: 44
Posts: 487
Trader Rating: (0)
![]() Feedback Score: 0 reviews
|
2 more problems, i am almost ready to give up
ok this first one isnt that bad but. the gas light on my s13 goes on when i turn the car off and stays on, but when i turn car on it goes off. whats the deal? will this drain my battery? also when i first start my car there will be i guess u call it a miss fire, it idles fine at 1000rpm's but u hear a, put...... putput.... put put, whats that all about and how do i fix it? i checked the timing and it was at bout 18 0r 19 soo u got me. i dunno what the deal is. its also got new plugs, wires, cap, the only thing that i didnt change when i did the sohc-dohc swap was the coil, but it didnt do it this morning. i just had a whole bunch of other problems to deal with then. soo any ideas on my problems, by the way i am still tryin to figure out my clutch prob, which u can see here http://www.zilvia.net/f/showthread.php?t=73777
but anyways there are absolutly no leaks i looked all over the place, i just gotta keep pumpin the pedal as o drive it gets very anoying but i need to drive it tommorrow to school soooo. |
![]() |
![]() |
Sponsored Links |
![]() |
#2 |
Zilvia Junkie
![]() Join Date: Jan 2005
Location: philadelphia, pa
Age: 44
Posts: 487
Trader Rating: (0)
![]() Feedback Score: 0 reviews
|
![]() BUMP: i need help bad, i cant seem to figure it out, this is my daily driver, i hope someone can help me out, i am bout to sell the damn thing.
![]() ![]() ![]() ![]() ![]() ![]() |
![]() |
![]() |
![]() |
#3 | |
Leaky Injector
![]() Join Date: Nov 2003
Location: scottsdale, az
Posts: 116
Trader Rating: (0)
![]() Feedback Score: 0 reviews
|
Quote:
As for the "mis fires" to me it sounds like a bent exhaust valve or something. I'm only applying my old honda knowledge here tho. When i had a couple bent valves it would kinda put put a little bit. A good trick to see if you have bent valve is at idle, hold a dollar bill (or 8 1/2 x 11 piece of worn paper if you have a huge canon for an exhaust ![]() |
|
![]() |
![]() |
![]() |
Bookmarks |
|
|