Crankshaft Position Sensor on s13 tranny (obd2 s14) - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

d4vech3n · 06-05-2005, 03:48 PM

I need a legit inspeciton after my mishap with the law.

I had done an auto to manual and the codes that came up on the diagnos were Intake Temperature Sensor. I have an 97 and the injen intake was designed for 95-96 IAT sensors so it fell off while driving. I think picking up that part will solve that problem.

Other codes were for a/t connecting lines and inhibitor switch which should be solved when a 5 speed obd2 ECU is dropped in.

Another code is for the Crankshaft positioning sensor. My car has an s13 tranny so I would have to custom fit mine to work. Has anybody ever done this before? Also will the auto crankshaft position sensor work? Any help is appreciated.

I already know it doesn't do anything for the car but I need it for inspection.

orion::S14 · 06-06-2005, 06:59 AM

You'll need to drill the hole in the top of the bellhousing...see if you can get your hands on a S14 trans to measure where to drill.

Easy stuff...but you'll need to pull the trans to do it.

And IIRC, the sensors are the same, for 5-speed and auto.

Good luck with it.

- Brian

06-05-2005, 03:48 PM	#1
d4vech3n Zilvia Member Join Date: Oct 2004 Location: NJ Posts: 271 Trader Rating: (0) Feedback Score: 0 reviews	Crankshaft Position Sensor on s13 tranny (obd2 s14) I need a legit inspeciton after my mishap with the law. I had done an auto to manual and the codes that came up on the diagnos were Intake Temperature Sensor. I have an 97 and the injen intake was designed for 95-96 IAT sensors so it fell off while driving. I think picking up that part will solve that problem. Other codes were for a/t connecting lines and inhibitor switch which should be solved when a 5 speed obd2 ECU is dropped in. Another code is for the Crankshaft positioning sensor. My car has an s13 tranny so I would have to custom fit mine to work. Has anybody ever done this before? Also will the auto crankshaft position sensor work? Any help is appreciated. I already know it doesn't do anything for the car but I need it for inspection.

06-06-2005, 06:59 AM	#2
orion::S14 Nissanaholic! Join Date: May 2003 Location: Orange Park, FL Posts: 1,666 Trader Rating: (0) Feedback Score: 0 reviews	You'll need to drill the hole in the top of the bellhousing...see if you can get your hands on a S14 trans to measure where to drill. Easy stuff...but you'll need to pull the trans to do it. And IIRC, the sensors are the same, for 5-speed and auto. Good luck with it. - Brian __________________ www.KA24DEvelopment.com