sr20det swapping problem. HELP ADVISE. - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

avirex_racing · 05-11-2002, 03:06 PM

Please help. I need some input.

I just started the swap today.the swap of a s13 redtop to my 95 240sx. I pulled the engine and put the sr20det in.This is were the problems started to pop up. The motor mounts are higher up so the sr20det is sitting up. I figured out that this was a problem because the tranny (bell housing is hitting the frame).

Problem #2: Some pipe coming from a release unit(sitting right around the level of the valve cover on the turbo side) The pipe is hitting the steering arm. I tried turing and the pipe is hitting.

Problem #3: Need ingintor chip.but people are telling me to use the ka24de distrubitor cap.

05-11-2002, 03:06 PM	#1
avirex_racing Join Date: Apr 2002 Posts: 14 Trader Rating: (0) Feedback Score: 0 reviews	Please help. I need some input. I just started the swap today.the swap of a s13 redtop to my 95 240sx. I pulled the engine and put the sr20det in.This is were the problems started to pop up. The motor mounts are higher up so the sr20det is sitting up. I figured out that this was a problem because the tranny (bell housing is hitting the frame). Problem #2: Some pipe coming from a release unit(sitting right around the level of the valve cover on the turbo side) The pipe is hitting the steering arm. I tried turing and the pipe is hitting. Problem #3: Need ingintor chip.but people are telling me to use the ka24de distrubitor cap.