How to replace a Nissan 240sx Engine Coolant Temperature Sender - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Carbonsnail · 04-19-2025, 04:52 PM

I have a stock 1992 S13 with a KA24de motor. Do I have to drain the coolant when replacing both of the Coolant Temperature Sensors on my car? Thank you.

AKADriver · 04-24-2025, 08:17 PM

No, only a little bit will spill out because it's close to the top of the system. Put some rags under them, work quickly and top it off when you're done.

Carbonsnail · 04-27-2025, 02:34 PM

AKADriver, thanks again for your response. Do I have to burp it once I'm
finished?

04-19-2025, 04:52 PM	#1
Carbonsnail Join Date: Aug 2020 Location: Lancaster CA Age: 62 Posts: 45 Trader Rating: (0) Feedback Score: 0 reviews	How to replace a Nissan 240sx Engine Coolant Temperature Sender I have a stock 1992 S13 with a KA24de motor. Do I have to drain the coolant when replacing both of the Coolant Temperature Sensors on my car? Thank you.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

04-24-2025, 08:17 PM	#2
AKADriver Post Whore! Join Date: May 2002 Location: Springfield, VA Age: 43 Posts: 3,517 Trader Rating: (1) Feedback Score: 1 reviews	No, only a little bit will spill out because it's close to the top of the system. Put some rags under them, work quickly and top it off when you're done.

04-27-2025, 02:34 PM	#3
Carbonsnail Join Date: Aug 2020 Location: Lancaster CA Age: 62 Posts: 45 Trader Rating: (0) Feedback Score: 0 reviews	AKADriver, thanks again for your response. Do I have to burp it once I'm finished?