GA Calipers/ Z32 Stainless Lines / 240sx rear stainless lines / Z32 Backing Plate/ More!

[shinhed]

Ok, Im now getting to the bottom of my parts bin and found these items. Most Items are brandnew.

StopTech Rear S-chassis stainless brake lines $25 Shipped

• NIB

Z32 Front/Rear Teflon & Stainless brake lines $65 Shipped

• Does not fit 240sx front w/o Earls Fitting 592032ERL or similar adapter

Z32 Front Rotor/Caliper Backing plates $45 Shipped

• Does not fit 240sx front

S14 240sx Front Calipers and stock lines $40 Shipped

• From Automatic car with only 77K Miles
• Plenty of pad life left

S14 Slotted and Drilled Rotors $40 shipped

• Probably less than 5k miles on them.
• Car they came off of was not a daily.

[shinhed]

BuMp

Get Some!

[fjarosz]

Do you have any z32 front caliper bolts? I'm missing one after I had mine powder coated

[shinhed]

Sorry, but funny you say that. I too am missing the right length one (bolt was over-torqued on reassembly and snapped).

It's a Flanged 10x100mm 1.25 thread pitch bolt (at least on 30mm calipers)

[R32CoupeS13]

Stock 240sx front caliper bolts will work on Z32 front. Same grade and thread pitch.

[shinhed]

Sure he's not talking about the bolts that hold the caliper halves together?

[R32CoupeS13]

Hmmm good point. Good luck finding those. Nissan says not to remove those bolts, so I doubt anyone manufactures them.

[fjarosz]

Yes I am talking about the bolts that hold the halves together. You have to split them to powder coat them and they are easy to rebuild you just need to get the square cut o rings

[shinhed]

Make me some offers.

[s13_whoa]

Will both s14 front calipers and front rotors? Im assuming will they fit on front s13?

[shinhed]

I'm assuming they do.