injen CAE - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

project_240 · 05-11-2002, 02:06 AM

i got the intake part in just fine...but the CAE looks like you have to cut a part of the engine bay to make the pipe fit. anyone know if this is necessary? and if not, how the heck do you fit that thing in that small hole??

-jake

9524tee · 05-12-2002, 01:58 AM

take off the resonater box ... then there will be a hole there , apply the tubing in that hole , place filter on pipe below ... kapeesh?

fadenb · 05-12-2002, 02:12 AM

thats right but dont forget to remove te tire and the fender guard. You might want to replace it if its in bad condition before the rain comes again. I got water all over my filter from the tire spin and put out the spark. replaced the cover and no more problems.

s13silady · 05-13-2002, 12:59 AM

after you remove your wheel wells, there should be couple bolts holding down your resonator.... after you take those bolts out there should be hella room in the engine bay.... but you might have to make the hole a little bigger......so that the cold air tubing will fit...

05-12-2002, 01:58 AM	#2
9524tee Zilvia Junkie Join Date: Nov 2001 Location: Lexington KY Posts: 545 Trader Rating: (0) Feedback Score: 0 reviews	take off the resonater box ... then there will be a hole there , apply the tubing in that hole , place filter on pipe below ... kapeesh? __________________ Nancy Kappa Monkey Squad

05-12-2002, 02:12 AM	#3
fadenb Join Date: Jan 2002 Location: Pittsburg, CA Posts: 48 Trader Rating: (0) Feedback Score: 0 reviews	thats right but dont forget to remove te tire and the fender guard. You might want to replace it if its in bad condition before the rain comes again. I got water all over my filter from the tire spin and put out the spark. replaced the cover and no more problems. __________________ Im out-e like your belly button

05-13-2002, 12:59 AM	#4
s13silady Nissanaholic! Join Date: May 2002 Location: Bay Area, San Jose Posts: 1,804 Trader Rating: (0) Feedback Score: 0 reviews	after you remove your wheel wells, there should be couple bolts holding down your resonator.... after you take those bolts out there should be hella room in the engine bay.... but you might have to make the hole a little bigger......so that the cold air tubing will fit... __________________

05-11-2002, 02:06 AM	#1
project_240 Leaky Injector Join Date: Mar 2002 Location: IE California Posts: 101 Trader Rating: (0) Feedback Score: 0 reviews	i got the intake part in just fine...but the CAE looks like you have to cut a part of the engine bay to make the pipe fit. anyone know if this is necessary? and if not, how the heck do you fit that thing in that small hole?? -jake