Redtop SR Wiring Mess HELP!!!

[CSXTacy]

Ok so i was blessed with the task of doing the wiring harness for a friend of mine's SR swap. The only problem is he ordered the motor and harness from a company in canada and instead of disconnecting connectors they just cut wires leaving me a cluster F#@k of wires. i got just about all the wires sorted out and cleaned up but i just have a few wires left that i am not sure of and are hoping u guys could help me out. here it goes:

(are these wires needed???)
*Blue/White wire Intake air temp sensor Pin #45 in ECU connector
*Blue/Yellow wire Exhaust gas sensor Pin #26 in ECU connector
*Purple/White wire Power steering oil pressure switch Pin #43 in ECU connector

i also have 2 wires that come from the coil pack connector down the harness and are cut on the other end one is a thick Blue/Red wire the other is a Red/Blue wire. (do these go to another connector? if so where?)


THANKS FOR ANY HELP!!!!

[attracted]

im pretty sure u need the air intake temp
you dnt need the exhaust gas and the power steering

the big blu/red is ign should go all the way next to the fuse box on the left(driver) side of the car

i'm not to sure red/blue but if its red/black then thats your ecu power

[CSXTacy]

yea i got the black/ red wire spliced to the proper connector. but the red/ blue wire is comming from the same coil pack connector as the big blue/red wire. Thanks for the help i really appreciate it!!! i just hope this thing starts on first crank! any other info would be greatly appreciated as well!!! THANKS GUYS!!!

[CSXTacy]

anyone?????? any further insight????

[sr20det drift]

make sure u have oil in the motor? jk