clutch install question - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Vatche · 04-29-2004, 01:43 AM

im gonna install the clutch with my brother and i was wondering if i needed to replace anything else while im down there....but not expensive shit cuz im broke

hahaha only things that need to be replaced and if there are any common problems, didnt find much in search

KOUKI KA-T · 04-29-2004, 12:02 PM

I always do rear main seal when replacing a clutch, at least if it's been a while or if you've never replaced it before.

HKrpS13 · 04-29-2004, 12:21 PM

check and see if the slave cylinder isn't leaking and check if the rubber is still in good condition.

JagdStealth · 04-29-2004, 01:17 PM

Resurface the flywheel, most shop swill do it for $10 or so on a lathe (even Pep boys sometimes).

You'll get more life out of the clutch and it'll work better.

aznxplayer · 04-29-2004, 02:18 PM

get a new throw out bearing (40 bucks?) and a clutch pilot bushing (5 bucks?)...not sure on the prices

04-29-2004, 01:17 PM	#4
JagdStealth Leaky Injector Join Date: Feb 2004 Location: San Diego, CA Posts: 125 Trader Rating: (0) Feedback Score: 0 reviews	Resurface the flywheel, most shop swill do it for $10 or so on a lathe (even Pep boys sometimes). You'll get more life out of the clutch and it'll work better. __________________ -Mike

04-29-2004, 02:18 PM	#5
aznxplayer Zilvia Member Join Date: Dec 2003 Location: Fremont, CA (bay area) Posts: 278 Trader Rating: (0) Feedback Score: 0 reviews	get a new throw out bearing (40 bucks?) and a clutch pilot bushing (5 bucks?)...not sure on the prices __________________ black 91 hatch R.I.P black 90 hatch sr20 R.I.P black 90 hatch!!!!

04-29-2004, 12:02 PM	#2
KOUKI KA-T Zilvia FREAK! Join Date: Feb 2003 Location: Portland, Maine Posts: 1,085 Trader Rating: (0) Feedback Score: 0 reviews	I always do rear main seal when replacing a clutch, at least if it's been a while or if you've never replaced it before.

04-29-2004, 12:21 PM	#3
HKrpS13 Zilvia Member Join Date: Dec 2001 Location: SoCal Posts: 267 Trader Rating: (0) Feedback Score: 0 reviews	check and see if the slave cylinder isn't leaking and check if the rubber is still in good condition.