Master and Slave cylinder leak, tranny mount bad

[wpayne]

I was driving down the rode yesterday and I took off from the light a little hard but not all out, when I tried to shift to second, the gear wouldn't go in! I pump the clutch and tried again, then tried all the gears and none worked. I pulled over and coasted to a parking lot where I tried to get the gears to go in, but I couldn't get it out of neutral. So tured off the car and it finally went in with a little force. I just messed around with it for a while 'till it finally went in normall. When i started my car, the car drove fine and everythig except that the car shaked a lot when I started off. So I took it to a mechanic and after checking it out, they said that both my slave and master clutch cylinders were leaking so they replaced it. I got the car back and it still shook when I took it off. So I took my car back and they checked it out again and found that the transmission mount was shot. He said it might cost like $200 to change it but I find that a little hard to believe.

Oh, and on top of that, after the incident when I was driving, the first time I tried to start it again my starter was making noise. So I guess coincidently my starter started going bad at the same time...

sucks to be me...