Installing BV TC Rods - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Tubed4evr · 03-03-2003, 12:49 PM

Hey guys I am about to put the battle version tension rods on my S13 and just wanted to know how other people adjusted them. It says on the website to start with the ends bottomed out and then adjut to length. Did you just eyeball to make it as close to the same length as stock rod? Did you just adjust it while it was on the car to make holes line up? I'm just about to put the car up so any help is appreciated.

Also for the people who have already intsalled these, was an alignment necessary?

Ryan

03-03-2003, 12:49 PM	#1
Tubed4evr Zilvia Member Join Date: Aug 2002 Location: Virginia Tech / Chesapeake, VA Posts: 223 Trader Rating: (0) Feedback Score: 0 reviews	Installing BV TC Rods Hey guys I am about to put the battle version tension rods on my S13 and just wanted to know how other people adjusted them. It says on the website to start with the ends bottomed out and then adjut to length. Did you just eyeball to make it as close to the same length as stock rod? Did you just adjust it while it was on the car to make holes line up? I'm just about to put the car up so any help is appreciated. Also for the people who have already intsalled these, was an alignment necessary? Ryan

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode