Extrude Honing - Recommendations - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

mattsil80wis · 12-09-2009, 07:56 PM

hey im good friends with cody ace and i built the same set up as him and im about 95% sure this is where we sent mine too

Kennametal Extrude Hone
Headquarters
235 Industry Blvd.
Irwin, PA 15642
USA
Get Map»
T: 724 863 5900
T: 1 800 367 1109 Toll Free
T: 1 800 613 0983 Service
F: 724 863 8759
www.extrudehone.com

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

12-09-2009, 07:56 PM	#4
mattsil80wis Zilvia Junkie Join Date: Jan 2008 Location: nj Age: 38 Posts: 391 Trader Rating: (6) Feedback Score: 6 reviews	hey im good friends with cody ace and i built the same set up as him and im about 95% sure this is where we sent mine too Kennametal Extrude Hone Headquarters 235 Industry Blvd. Irwin, PA 15642 USA Get Map» T: 724 863 5900 T: 1 800 367 1109 Toll Free T: 1 800 613 0983 Service F: 724 863 8759 www.extrudehone.com