Bad to have rotor not centered in the width of the wheel? - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

jspaeth · 02-01-2010, 11:10 AM

I have a buddy with an RB swapped 197x 260z.

He currently is running 15xsomething Work meshies in something like -20 offset or so.

He wants to run 13.5 inch rotors up front, but we think that the only way to get this to work, is going to be if the rotors are positioned (via offset and also spacers) very much near the INNER lip of the wheel.

Like if you look at the wheel from the front of the car, the rotor would be way towards the inner lip of the wheel.

Does anyone know of any negative effects/safety issues associated with the rotor/caliper being positioned quite far from the center of the wheel's width?

02-01-2010, 11:10 AM	#1
jspaeth Nissanaholic! Join Date: Mar 2006 Location: Philadelphia suburbs Age: 40 Posts: 2,347 Trader Rating: (7) Rides Gallery: jspaeth Feedback Score: 7 reviews	Bad to have rotor not centered in the width of the wheel? I have a buddy with an RB swapped 197x 260z. He currently is running 15xsomething Work meshies in something like -20 offset or so. He wants to run 13.5 inch rotors up front, but we think that the only way to get this to work, is going to be if the rotors are positioned (via offset and also spacers) very much near the INNER lip of the wheel. Like if you look at the wheel from the front of the car, the rotor would be way towards the inner lip of the wheel. Does anyone know of any negative effects/safety issues associated with the rotor/caliper being positioned quite far from the center of the wheel's width? __________________ Daily driven

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode