CA 400 whp track car part out

[P-Funk alot]

ok guys look i tried to sell it as a complete car but it didnt work out so if the motor set sells i will part the whole car out but the motor set has to sell first.

full 400 whp rb25 turn key swap i will not seperate any part from this set.
looking to get 5k OBO

so with that being said here are pics of the car complete and running so let me know guys. i am motivated but not deperate



rb25 series 1
apexi power fc and commander
d werks 750cc injectors
greddy intake mani
cx racing turbo mani
greddy bov
new turbo custom built by performance technique (full boost under 3500 rpm its crazy)
tial 38mm waste gate
aem wideband
blitz d-sbc
completely rebuilt head
tomei valve springs and retainers
also have tomei solid lifters
real nardi deep corn steering wheel
nrg quick disconnect and hub
z32 maf
q45 throttle body
full 5 lug conversion
z32 front calipers
z33 slotted and cross drilled track rotors
tein inner and outer tie rods
god speed coils with swift springs 10/8k (i like them better then my old teins)
all suspension arms are also godspeed
steel one piece drive shaft
syko mount kit motor and tranny (also have mckinney ones that will be thrown in)
wagner pads front and rear (thing stops on a dime)
50mm over fenders in the rear
20mm wide fenders in the front
act clutch good for 600 hp (thing is like an on and off switch grabs super hard)


leave you negative comments out of my thread everyone as different opinions.

here are some pics ill have more up tomorrow that are more current.







text me 909-763-0910